Standard Ignition UF-277 Ignition Control Module

Ignition Control Module for Volkswagen and Audi

The Standard Ignition UF-277 ignition control module is a 12-volt, distributorless ignition component built for engine-bay mounting on select Volkswagen and Audi applications. It uses a plug-in female connector, blade terminals, and a bolt-on mount with an included bracket for a direct replacement-style installation.

• 12-volt ignition control module for distributorless ignition systems
• Engine bay mounting with bolt-on mount type
• Plug-in connector with 1 female connector and 4 male blade terminals
• Black and silver housing with included mounting bracket
• Coil included for service on supported applications
• Cross-reference part numbers include 23-0447 and 032905106

Detailed Product Overview

Standard Ignition UF-277 is built for vehicles that use a distributorless ignition setup and an electronic coil arrangement. The oval and rectangle connector shapes, 4-terminal layout, and 12-volt electrical design make it a direct-fit ignition control module for specific Volkswagen Jetta, Beetle, Golf, Polo, Caddy, CrossFox, SportVan, Lupo, Sharan, Saveiro, Gol Sedan, Nuevo Gol, Clasico, and Audi A3 applications. This part number, UF-277, is also referenced under OE-style interchange numbers used for the same application.

Compatible With 1998-2023 Volkswagen and Audi applications listed in the fitment data, including 1998-2003 Audi A3 and multiple Volkswagen Jetta, Beetle, and Polo configurations. Fits 2010-2023 Volkswagen Saveiro, N/A; Fits 2006-2015 Volkswagen Jetta, N/A; Fits 1998-2003 Audi A3, N/A.

What This Part Helps Address

• Engine no-start conditions related to ignition module failure
• Misfire concerns caused by weak or inconsistent spark control
• Rough idle tied to distributorless ignition signal issues
• Intermittent stalling from failing electronic ignition control
• Loss of ignition output in supported Volkswagen and Audi systems

Installation Notes and Tips

Install the UF-277 in the engine bay using the bolt-on mounting style and verify the connector shape, terminal count, and ignition system type before replacement. Because mounting hardware and instructions are not included, transfer any reusable fasteners from the original setup and confirm the coil and connector match the vehicle’s original configuration. For fitment-specific applications such as 2018 Volkswagen Jetta, Eldor and 2016 Volkswagen Jetta, Eldor, verify the OE reference before installation.

Quality Assurance

Standard Ignition supplies ignition components for service replacement use, and this module is built to match the electrical and connector requirements shown in the fitment data. The UF-277 is listed with OE-style interchange references for the same application, supporting accurate part matching for Volkswagen and Audi ignition repairs.