Standard Ignition UF888 Ignition Coil

Ignition Coil for Distributorless Systems

Standard Ignition UF888 is a 12-volt electronic ignition coil built for distributorless ignition systems. It uses a bolt-on mount, a single male connector, and a 3-terminal male pin layout with rectangular and oval connector shapes for a direct-service replacement on the correct application.

For drivers searching for an ignition coil for Chrysler 300, Dodge Charger, or similar distributorless ignition system repairs, UF888 provides the electrical and connector configuration needed for a proper match. This Standard Ignition UF888 ignition coil is black, oil-free, and built for pin-style terminal connections.

Key Features

• 12-volt ignition coil for distributorless ignition systems
• Electronic coil type with bolt-on mounting
• 1 male connector with rectangular and oval connector shapes
• 3 male pin terminals for the specified application
• Black housing, non-oil-filled design
• Standard Ignition UF888 part number for service identification

Detailed Description

Standard Ignition UF888 is an ignition coil designed for distributorless ignition setups that require a bolt-on, electronic coil with a single connector interface. The 12-volt design, 3-terminal pin layout, and male connector configuration support accurate replacement when the original coil matches these specifications. If you are replacing a failed coil on a Chrysler 300 or Dodge Charger, verify the connector shape, terminal count, and mounting style before installation. This part cross-references 68308653AA for the same application.

Common Issues This Part Can Address

• Engine misfire caused by a weak or failed ignition coil
• Hard starting related to inconsistent spark output
• Rough idle from ignition system voltage loss
• Check engine light triggered by coil circuit faults
• Intermittent spark delivery in distributorless ignition systems

Installation Notes and Tips

Confirm the original coil uses a bolt-on mount, one male connector, and three male pin terminals before ordering. Match the connector shape and terminal layout to the vehicle harness, and inspect the coil boot, wiring, and nearby ignition components during replacement. Clear diagnostic trouble codes after installation and verify engine operation under idle and load conditions.

Quality Assurance

Standard Ignition supplies service parts for ignition system repair, and UF888 is built to match the listed electrical and connector specifications for the intended application.