Standard Ignition VHS143 Suspension Ride Height Sensor - Front Right

Front Right Ride Height Sensor for OE-Style Suspension Control

Standard Ignition VHS143 is a suspension ride height sensor built for front right applications on select Dodge and Jeep vehicles. It uses a bolt-on attachment, a black housing, and a plug-in oval connector to support a direct replacement-style installation.

Compatible With 2016-2023 Dodge Durango, front right; 2016-2021 Jeep Grand Cherokee, front right; and 2022 Jeep Grand Cherokee WK, front right. Standard Ignition VHS143 is also cross-referenced to OE and aftermarket numbers used for the same application.

Key Features

• Bolt-on suspension ride height sensor
• Black finish for a factory-style appearance
• Female oval connector with plug-in design
• 3 male blade terminals
• Built for front right ride height sensing applications
• Cross-references Monroe Shocks & Struts 172286 and 182286 for the same application

Product Details

This Standard Ignition suspension ride height sensor monitors vehicle ride height at the front right corner and sends position data to the suspension system. On equipped Dodge Durango and Jeep Grand Cherokee models, accurate sensor input helps the system maintain proper suspension response and ride-leveling operation. The VHS143 part number is a direct-fit style replacement for vehicles listed in the fitment data, including 2016-2023 Dodge Durango, 2016-2021 Jeep Grand Cherokee, and 2022 Jeep Grand Cherokee WK.

Standard Ignition VHS143 is a practical choice when replacing a worn or damaged front right ride height sensor on a Dodge Durango or Jeep Grand Cherokee. The oval female connector, 3-blade terminal layout, and bolt-on mounting style support straightforward OE-style service work.

Common Issues This Part May Address

• Suspension warning messages related to ride height sensor input
• Uneven vehicle stance caused by inaccurate front right height readings
• Poor suspension leveling response on equipped systems
• Fault codes tied to ride height sensor performance
• Intermittent sensor signal from a damaged connector or worn sensor

Installation Notes

Install at the front right suspension position only on the listed applications. Verify connector shape, terminal count, and mounting style before installation to confirm match with the original sensor. After replacement, clear any stored suspension codes and confirm proper ride height system operation.

Quality Assurance

Standard Ignition supplies replacement electrical and sensor components for service applications, and VHS143 is built to match the listed fitment and connector specifications for the vehicles shown.