Standard Wires 55402 Spark Plug Wire Set

Ignition Wire Set for OE-Style Performance

Standard Wires 55402 is a spark plug wire set built for direct-fit ignition service on select Chevrolet and Suzuki applications. It uses a hi-gloss clear coat over a high-temperature silicone jacket to improve abrasion resistance and heat protection while helping deliver voltage efficiently to the spark plugs.

Compatible With 2004-2008 Suzuki Forenza, 2004-2006 Chevrolet Astra, and 2005-2008 Chevrolet Tracker. Standard Wires 55402 is a practical replacement for worn ignition leads that can affect starting, idle quality, and engine performance.

Key Features

• Patented clear-coat exterior with a high-temperature silicone jacket
• OE-matched core design for low resistance and stable ignition transfer
• Improved abrasion resistance for demanding underhood conditions
• Enhanced protection against severe heat
• Built to channel voltage to the spark plug with added RFI control
• Standard Wires 55402 for select Chevrolet and Suzuki vehicles

Detailed Description

This spark plug wire set is engineered around OE-type core construction, using a design matched to common factory-style ignition requirements such as low-ohm, ferrite mag, wire-wound, silicone, or metallic core layouts. The result is a replacement that supports consistent spark delivery while helping reduce electrical interference. For drivers servicing a Chevrolet Tracker, Chevrolet Astra, or Suzuki Forenza, Standard Wires 55402 provides a direct ignition wire solution for routine maintenance or repair.

Common Issues It Can Address

• Hard starting caused by deteriorated ignition wires
• Misfire symptoms from cracked or heat-damaged leads
• Rough idle related to inconsistent spark delivery
• Electrical noise or radio interference from worn insulation
• Visible abrasion or heat wear on existing plug wires

Installation Notes and Tips

Match each wire to the correct cylinder routing before removal, and transfer one lead at a time to preserve firing order. Inspect boots, coil connections, and plug terminals during installation, and confirm the wires are fully seated at both ends. For best results, route the wires away from hot exhaust components and sharp edges.

Quality Assurance

Standard Wires 55402 is built with materials and core construction intended to meet OE-style ignition service requirements for the listed applications. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.