Standard Wires 55940 Spark Plug Wire Set

Ignition Wire Set for Toyota Tercel and Corolla

Standard Wires 55940 is a spark plug wire set for select Toyota applications from the 1983-1988 model years. It is built with a hi-gloss clear coat and a high-temperature silicone jacket to help protect the wires in demanding engine bay conditions.

Key Features

• Patented clear-coat outer finish for added abrasion resistance
• High-temperature silicone jacket for heat protection
• OE-type core design matched to the original application
• Low-ohm, ferrite mag, wire-wound, silicone, or metallic core construction depending on OE specification
• Enhanced RFI protection for cleaner ignition performance
• Channels voltage efficiently to the spark plug

Detailed Description

Standard Wires 55940 is engineered as a direct ignition service part for Toyota Corolla and Toyota Tercel models listed below. The wire set uses a core design matched to OE-style requirements to support consistent spark delivery while the silicone jacket and clear-coat finish add protection against heat and abrasion. For drivers servicing a Toyota Tercel spark plug wire set or a Toyota Corolla ignition wire replacement, this part number 55940 provides a focused fitment solution for the specified emissions configurations.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Vehicle Fitment

• Fits 1988 Toyota Tercel, N/A, w/o Cap
• Fits 1984-1987 Toyota Corolla, N/A, w/ U.S. Emissions
• Fits 1987 Toyota Tercel, N/A, w/ Calif. Emissions
• Fits 1983-1986 Toyota Tercel, N/A
• Fits 1983 Toyota Corolla, N/A

Common Issues This Part May Address

• Misfires caused by worn or heat-damaged plug wires
• Hard starting related to weak spark transfer
• Intermittent ignition performance from cracked insulation
• Radio frequency interference from deteriorated wire construction
• Voltage loss between the ignition system and spark plugs

Installation Notes and Tips

Verify the vehicle’s emissions configuration and cap style before ordering, since fitment varies by year and application. Route each lead to match the original layout and keep the wires separated from hot or moving components. Confirm the wire ends are fully seated at the distributor and spark plugs during installation.

Quality Assurance

Standard Wires 55940 is built with OE-matched core design and protective materials selected for ignition service in Toyota Corolla and Toyota Tercel applications. The construction focuses on heat resistance, abrasion protection, and RFI control for dependable replacement use.