Sunsong 2201771 Brake Hydraulic Hose - Front Left

Brake Hose for Nissan Maxima Front Left

Sunsong 2201771 is a front left brake hydraulic hose for 2009-2014 Nissan Maxima applications. It is built to restore original hose routing and connection points while supporting reliable brake fluid transfer at the wheel end.

• Compatible with 2009-2014 Nissan Maxima, front left
• Precision-engineered OE-style fit for direct replacement use
• EPDM hose material for brake system service conditions
• Banjo end fitting on one end and female fitting on the other
• 10 mm fitting size at both ends
• Includes bracket and required wear components such as grommets, molded plastic guards, wire clips, and protective sleeves as required
• Brake hose tubing uses high-grade steel with zinc electroplating for corrosion resistance
• High-pressure tested before shipment for installation and operation checks

Detailed Product Overview

This Sunsong brake hydraulic hose, part number 2201771, is engineered for the front left position on the Nissan Maxima from 2009 through 2014. The hose measures 21.85 inches (555.1 mm) and uses an EPDM hose construction with 10 mm fittings, including a banjo end and a female end. For vehicles that use a banjo connection, new copper washers are included to support proper sealing at the connection point.

Built to meet or exceed DOT, FMVSS 106, and SAE J1401 standards, this hose is made for brake system service where fit, routing, and sealing matter. Sunsong 2201771 is a direct-fit replacement for the original front left brake hose on the Nissan Maxima and is also referenced by cross numbers such as Dorman - First Stop H621581 and Raybestos Brakes BH383556 for the same application.

Common Problems This Hose Can Address

• Cracked or deteriorated brake hose rubber
• Brake fluid seepage at the hose connection
• Restricted fluid flow from an internally damaged hose
• Corrosion at the hard line or fitting area
• Incorrect hose routing after prior brake service

Installation Notes

Verify the front left position, fitting style, and 10 mm connection sizes before installation. Inspect the mounting bracket, line routing, and adjacent brake components for wear or corrosion, and replace any damaged sealing surfaces before bleeding the system. After installation, bleed the brake system and check all connections for leaks.

Quality Assurance

Each hose is pressure tested before leaving the factory. Sunsong also specifies corrosion-resistant zinc-coated steel tubing and compliance with DOT, FMVSS 106, and SAE J1401 standards for brake hose construction.