Sunsong 3401097 Power Steering Pressure Line Hose Assembly

Power Steering Pressure Line for Windstar

This Sunsong power steering pressure line hose assembly is built for 1996-1998 Ford Windstar applications and is engineered to handle demanding steering-system pressure. Part number 3401097 is made to match the original routing and connection style for a direct replacement on the specified vehicle fitment.

• Fits 1996-1998 Ford Windstar, N/A
• Pressure hose assembly with 16 mm long swivel O-ring end and 17 mm swivel O-ring end
• 48.3 in. (1227 mm) hose length for application-specific routing
• CSM hose material for durability in power steering service
• Built to exceed original equipment performance standards with 1,500 psi max working pressure
• 8,700 psi burst pressure rating and 1,600 lb tensile strength
• High-grade steel tubing with zinc electroplating for corrosion resistance

Detailed Product Overview

Sunsong 3401097 is a power steering pressure line hose assembly for the Ford Windstar, designed to restore proper hydraulic flow between steering components. The hose uses a 16 mm long swivel O-ring fitting on one end and a 17 mm swivel O-ring fitting on the other, with a 48.3-inch overall length to match the vehicle’s original layout. This makes it a practical choice for a Ford Windstar power steering pressure hose replacement when the original line is leaking, damaged, or no longer holding pressure.

The assembly is manufactured with high-grade steel tubing and zinc coating to resist rust and corrosion from humidity, road salt, water, and grime. Sunsong part number 3401097 is also pressure-tested before it leaves the factory to help support consistent installation and operation. This part cross-references Edelmann 91980 and FEL-PRO 70032 for the same application.

Common Problems This Part Can Address

• Power steering fluid leaks from a worn or damaged pressure line
• Loss of steering assist caused by pressure loss in the hydraulic circuit
• Noise or stiffness in steering linked to restricted hose flow
• Corrosion-related hose failure on older Ford Windstar models
• Fitment issues when replacing an original pressure hose with the correct O-ring connection style

Installation Notes and Tips

Confirm the end fitting sizes and hose routing before installation. This assembly uses swivel O-ring connections, so clean sealing surfaces and inspect mating components for wear before tightening. Verify that the replacement line follows the original path and clears nearby heat and moving components on the Ford Windstar.

Quality Assurance

Each Sunsong pressure hose assembly is high-pressure tested at the factory before shipment. The construction is specified to meet or exceed original equipment performance standards, with corrosion-resistant tubing and pressure ratings suited for power steering service. Part number 3401097 is built for direct-fit replacement on 1996-1998 Ford Windstar applications.