Suspensia X01CJ1500 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

Front Right Lower Control Arm for Audi TT Quattro

Suspensia X01CJ1500 is a front right lower suspension control arm and ball joint assembly for select Audi performance coupes and roadsters. It is built with forged aluminum construction, a bolt-in ball joint, and pre-greased components for OE-style service fitment on the front suspension.

Key Features

• Forged aluminum arm with steel housing
• Ball joint included with threaded stud design
• Pre-greased for initial installation
• Rubber bushings and rubber dust boot included
• Black bushing and boot finish
• Lock nut included; castle nut and cotter pin not included
• Stud thread size: M12 x 1.5
• Wrench size: 15 mm

Detailed Description

Suspensia X01CJ1500 is engineered as a direct OE-fit replacement for the front right lower position on 2016-2021 Audi TT Quattro, 2018-2021 Audi TT RS Quattro, and 2016-2021 Audi TTS Quattro. This assembly combines the control arm and ball joint into one service part, helping restore proper suspension geometry, steering response, and wheel control when the original component is worn or damaged. The forged aluminum arm, rubber bushings, and bolt-in ball joint construction support a factory-style replacement for Audi TT Quattro front suspension service. This part cross-references Monroe Shocks & Struts (e.g., 172286) for the same application. Part number X01CJ1500 is a direct-fit option for Audi TT Quattro front right lower suspension repair.

Common Problems This Part Can Address

• Clunking or knocking from the front suspension
• Excessive play in the control arm or ball joint
• Uneven tire wear caused by worn suspension joints
• Loose or imprecise steering feel
• Visible cracking or deterioration in bushings or dust boot

Installation Notes and Tips

Verify the front right lower position before installation and compare the original arm, ball joint stud type, and mounting points to the replacement part. Because this assembly uses a bolt-in ball joint and threaded stud, proper torque procedures should be followed during installation. An alignment is recommended after suspension component replacement. Confirm fitment by vehicle year, model, and position before ordering X01CJ1500.

Quality Assurance

Suspensia manufactures chassis parts to OE or better quality standards and supplies direct OE-fit components for the North American aftermarket. The brand states its parts are produced in a highly automated facility in Turkiye that operates under IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 certifications. Part number X01CJ1500 is built to support consistent fit and finish for Audi TT Quattro, Audi TT RS Quattro, and Audi TTS Quattro front suspension service.