Suspensia X05TA0060 Steering Tie Rod End Assembly - Front Left

Front Left Tie Rod End for BMW X5 X6 X7

The Suspensia X05TA0060 steering tie rod end assembly is built for direct OE fit and OE look on select BMW front suspension applications. It uses forged steel construction, a steel stud, and a pre-greased design with a rubber dust boot for dependable steering linkage service.

• Forged steel housing for strength in steering service
• Steel ball joint stud with threaded stud type
• Pre-greased and sealed with a black rubber dust boot
• Locking nut included
• Non-greaseable design for low-maintenance operation
• Composite bearing material
• Direct OE fit replacement for front left steering linkage service

Detailed Product Overview

Suspensia X05TA0060 is a steering tie rod end assembly engineered for the front left side on 2019-2021 BMW X5, 2020-2021 BMW X6, and 2019-2021 BMW X7. This part number X05TA0060 is built in an OE manufacturing environment and is intended to match factory fit and appearance for BMW steering repair work. The assembly includes a rubber boot, pre-greased internal components, and a threaded male/female end configuration for the specified application.

This part cross-references Mevotech Supreme MS106260 for the same application.

Common Repair Symptoms

• Loose or vague steering feel
• Front-end wandering or poor directional control
• Uneven tire wear from worn steering linkage
• Clunking or play in the front left steering connection
• Failed dust boot or contaminated tie rod end joint

Installation Notes

Install on the front left position only for the listed BMW applications. Verify thread orientation and steering geometry before final tightening, and perform a wheel alignment after replacement. The locking nut is included; castle nut, cotter pin, grease fitting, washers, and adjusting sleeve are not included.

Quality Assurance

Suspensia manufactures chassis parts to OE or better quality standards in an IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 certified facility. The brand states its steering and chassis components are produced in a fully automated OE manufacturing environment for consistent fit and finish.