Suspensia X07CJ1071 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

Front Right Lower Control Arm Assembly

Suspensia X07CJ1071 is a front right lower suspension control arm and ball joint assembly built for direct OE fit and OE appearance. It is a steel replacement part with a pre-greased, press-in ball joint, rubber bushings, and a rubber dust boot for service-ready installation on select Cadillac, Chevrolet, and GMC trucks and SUVs.

Compatible with 2014-2019 Chevrolet Silverado 1500, 2015-2020 Chevrolet Tahoe, 2015-2020 Cadillac Escalade, and other listed applications, this assembly is built for the front right lower position. The Suspensia X07CJ1071 is also a direct cross-reference for Dorman OE Solutions 527-064 and MOOG RK623299 for the same application.

• Steel housing and arm construction
• Pre-greased ball joint included
• Press-in ball joint mounting with threaded stud
• Rubber bushings and rubber dust boot included
• Black bushing and boot finish
• Lock nut included
• Direct OE fit and OE look

Application Details

This suspension control arm and ball joint assembly is engineered for the front right lower position on 2014-2019 Chevrolet Silverado 1500, 2015-2020 Chevrolet Tahoe, 2015-2020 GMC Yukon, 2015-2020 GMC Yukon XL, 2015-2020 Cadillac Escalade, and 2015-2020 Cadillac Escalade ESV. It uses a steel housing, plastic bearing material, and a threaded M16 x 2 stud size with a 24 mm wrench size.

Suspensia manufactures chassis parts in a fully automated OE manufacturing facility in Turkiye and builds to OE or better quality standards for the North American aftermarket. Part number X07CJ1071 is a practical replacement when the original control arm shows wear at the ball joint, bushings, or mounting points.

Common Repair Symptoms

• Front-end clunking or popping over bumps
• Uneven tire wear from worn suspension geometry
• Loose or unstable steering feel
• Excessive play from a worn ball joint
• Cracked or deteriorated control arm bushings

Installation Notes

Verify vehicle trim and front right lower fitment before installation. The ball joint is press-in and the assembly is pre-greased, so no grease fitting is provided. Castle nut and cotter pin are not included; confirm the vehicle-specific fasteners and torque specifications during service. Inspect adjacent suspension components and alignment settings after replacement.

Quality Assurance

Suspensia chassis parts are produced in an IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 certified facility with high-volume automated production. X07CJ1071 is built to OE fit and OE look standards for consistent replacement quality.