Suspensia X09TE0835 Steering Tie Rod End - Front Inner

Suspensia X09TE0835 Steering Tie Rod End

Suspensia X09TE0835 is an outer steering tie rod end built for direct OE fit and OE appearance. It is pre-greased, uses a steel housing with an e-coated finish, and includes a dust boot and locking nut for a clean, service-ready replacement.

Compatible with front inner steering applications on select Dodge, Chrysler, and Imperial models, this part number is a practical choice for restoring steering linkage integrity on classic vehicles such as the Dodge Charger and Dodge Dart.

Key Features

• Part number: X09TE0835
• Outside tie rod end for steering linkage service
• Pre-greased design
• Steel housing with e-coated finish
• Rubber dust boot with black neoprene boot material
• Threaded ball joint stud with male end 2 thread gender
• Locking nut included
• Grease fitting not included; non-greaseable design

Detailed Description

Suspensia manufactures chassis components to OE or better quality standards for the North American aftermarket, with production in a fully automated facility in Turkiye. X09TE0835 is built as a direct-fit steering tie rod end with steel bearing material, regular grade construction, and pre-installed lubrication for straightforward replacement service. The e-coated finish adds corrosion resistance, while the dust boot helps protect the joint from road contamination. This part cross-references MOOG Chassis Products ES319L for the same application.

Compatible With 1962 Dodge Lancer, front inner; 1962-1969 Dodge Dart, front inner; 1962-1965 Chrysler Imperial, front inner; and 1966-1969 Dodge Charger, front inner. Use X09TE0835 when servicing the front inner steering linkage on these vehicles, including Dodge Charger and Dodge Dart applications.

What It Helps Address

• Loose or worn steering linkage at the front inner tie rod location
• Steering play caused by joint wear
• Uneven steering response from a deteriorated tie rod end
• Boot damage that exposes the joint to dirt and moisture
• Corrosion on an older steering component

Installation Notes and Tips

Inspect the steering linkage, adjusting sleeve, and related hardware before installation. Because this is a non-greaseable tie rod end, no grease fitting is provided. After installation, perform a professional alignment and verify steering wheel center, toe setting, and fastener torque according to the vehicle service manual.

Quality Assurance

Suspensia chassis parts are produced in an IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 certified facility with high-volume automated manufacturing controls. Part number X09TE0835 is built to OE fit and OE look standards for consistent replacement quality.