Suspensia X15CJ1128 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

Suspension Control Arm Assembly for Ford and Mercury

Suspensia X15CJ1128 is a front right lower suspension control arm and ball joint assembly built for direct OE fit and OE appearance. It is engineered for 2008-2009 Ford Taurus, 2008-2009 Ford Taurus X, 2008-2009 Mercury Sable, and 2009 Ford Flex applications.

• Steel construction for strength and consistent suspension support
• Pre-greased ball joint for ready-to-install service
• Rubber bushings and rubber dust boot for controlled movement and protection
• Black bushing and boot finish for OE-style appearance
• Lock nut included; castle nut, cotter pin, and grease fitting not included
• Stud thread size: M14 x 2; wrench size: 21 mm

Fitment and Application Details

Fits 2009 Ford Flex, front right lower. Fits 2008-2009 Ford Taurus, front right lower. Fits 2008-2009 Ford Taurus X, front right lower. Fits 2008-2009 Mercury Sable, front right lower. This part cross-references Dorman OE Solutions 524-218 for the same application.

Part number X15CJ1128 is a direct-fit suspension control arm and ball joint assembly for the front right lower position. It is built to match OE dimensions and mounting points, helping maintain proper suspension geometry on Ford Taurus, Ford Taurus X, Mercury Sable, and Ford Flex models listed above.

What This Part Helps Address

• Front-end clunking or knocking from a worn control arm assembly
• Excessive play caused by a failing ball joint
• Uneven tire wear related to suspension looseness
• Steering pull or unstable road feel from worn bushings
• Noise and vibration from deteriorated rubber components

Installation Notes and Tips

Verify the front right lower position and confirm stud thread size M14 x 2 before installation. Because this assembly is pre-greased and not greaseable, no grease fitting is required. Use the included lock nut as specified by the vehicle service procedure, and inspect adjacent suspension components, alignment settings, and fasteners during replacement.

Quality Assurance

Suspensia manufactures chassis parts in an OE-focused facility using automated assembly processes. The production environment is certified to IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 standards, supporting consistent manufacturing control for this suspension control arm and ball joint assembly.