Suspensia X15CJ1130 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

Suspension Control Arm Assembly for Ford and Mercury

Suspensia X15CJ1130 is a front right lower suspension control arm and ball joint assembly built for OE-style fit and appearance. It is a steel replacement part with a pre-greased, non-greaseable ball joint, rubber bushings, and a rubber dust boot for service-ready installation.

Compatible with 2008-2009 Ford Taurus, 2008-2009 Ford Taurus X, 2009 Ford Flex, and 2008-2009 Mercury Sable in the front right lower position, this assembly is a direct-fit option for common suspension service on these platforms. The X15CJ1130 part number is also useful when cross-checking replacement listings for the same application.

Key Features

• Steel control arm construction
• Front right lower position
• Pre-greased ball joint
• Rubber bushing material with black bushings
• Rubber dust boot included
• Lock nut included
• Stud thread size: M14 x 2
• Wrench size: 21 mm
• Non-greaseable design

Detailed Product Overview

Suspensia manufactures chassis components to OE or better quality standards for the North American aftermarket, with direct OE fit and OE look construction. X15CJ1130 is produced in a fully automated facility and built to match the geometry and service requirements of the original suspension layout on Ford Flex, Taurus, Taurus X, and Mercury Sable applications. The assembly uses steel for strength, rubber for the bushings and dust boot, and a pre-greased joint to simplify replacement work. This part cross-references Dorman OE Solutions 521-988 for the same application.

Common Repair Symptoms

• Clunking or knocking from the front suspension
• Excessive play in the front right lower control arm
• Uneven tire wear caused by worn suspension joints
• Loose or unstable steering feel
• Visible cracking or deterioration in the bushings or dust boot

Installation Notes and Tips

Install X15CJ1130 in the front right lower position only on the listed vehicles. Verify stud thread size, mounting points, and alignment settings before final tightening. Because the assembly is pre-greased and not greaseable, no grease fitting service is required after installation. A professional wheel alignment is recommended after suspension replacement.

Quality Assurance

Suspensia chassis parts are manufactured in an IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 certified facility with automated production controls. X15CJ1130 is built as an OE-fit replacement for consistent dimensional accuracy and repeatable assembly quality.