Suspensia X15TE0839 Steering Tie Rod End - Front Right Outer

Steering Tie Rod End for OE-Style Front Right Service

Suspensia X15TE0839 is an outside steering tie rod end built for direct OE fit and OE look service on the front right side. It is pre-greased, greaseable, and supplied with a dust boot, castle nut, cotter pin, and grease fitting for a complete replacement assembly.

Key Features

• Outside steering tie rod end
• Fits the front right outer steering position
• Pre-greased and greaseable
• Steel housing with e-coated finish
• Rubber dust boot with black neoprene boot material
• Threaded ball joint stud and steel bearing material
• Castle nut, cotter pin, dust boot, and grease fitting included
• Direct OE fit and OE look construction

Detailed Product Overview

Suspensia X15TE0839 is engineered as a steering tie rod end for vehicles that require a front right outer replacement. It is built with a steel housing, threaded ball joint stud, and greaseable design to support steering linkage service. The e-coated finish adds corrosion resistance, while the rubber dust boot helps protect the joint from road contamination. This part cross-references MOOG Chassis Products ES336R and Delphi TA5274 for the same application. It is a strong match for classic Ford Mustang steering repair work, including 1964-1966 Ford Mustang front right outer service, and also lists 1965 Mercury Villager front right outer fitment. Part number X15TE0839 is the reference to use when verifying the correct steering linkage component.

Vehicle Fitment

• Fits 1964-1966 Ford Mustang, front right outer
• Fits 1965 Mercury Villager, front right outer

What This Part Helps Address

• Loose or worn steering response at the front right outer linkage
• Excess play in the steering wheel caused by tie rod end wear
• Uneven tire wear related to steering geometry issues
• Clunking or knocking from a worn steering joint
• Corrosion or boot damage on the original tie rod end

Installation Notes

Verify the front right outer position before installation and confirm thread orientation, stud type, and vehicle application against the existing part. After replacement, a professional wheel alignment is recommended to restore steering geometry. Part number X15TE0839 should be matched to the vehicle’s steering linkage configuration before service begins.

Quality Assurance

Suspensia manufactures chassis parts to OE or better quality standards in an IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 certified facility. Production is supported by automated assembly lines and OE-fit engineering for consistent replacement quality.