Suspensia X17CJ0100 Suspension Control Arm and Ball Joint Assembly - Front Left Lower

Suspension Control Arm Assembly for Honda Odyssey

Suspensia X17CJ0100 is a suspension control arm and ball joint assembly built for the front left lower position on select Honda Odyssey models. It combines a cast steel arm, press-in ball joint, and rubber bushings to restore proper suspension geometry and steering response.

Compatible with 2005-2006 Honda Odyssey, front left lower, this assembly is pre-greased and includes the ball joint, dust boot, cotter pin, and castle nut. Part number X17CJ0100 is also a direct reference for shoppers comparing OE-style replacement options for the Honda Odyssey front suspension.

Key Features

• Cast steel arm with steel housing for strength and durability
• Press-in ball joint with threaded stud, M14 x 2 thread size
• Pre-greased design with no grease fitting required
• Includes bushings, dust boot, cotter pin, and castle nut
• Rubber bushings and rubber dust boot with black finish
• 21 mm wrench size
• Cross-reference: MOOG Chassis Products RK620505

Detailed Description

This Suspensia control arm assembly is manufactured in Turkey in IATF 16949 certified factories under ISC Industries, a supplier to OE Tier 1 programs for Ford, Fiat/Chrysler, Volkswagen Group, and Renault/Nissan. The X17CJ0100 uses a cast steel arm, plastic bearing material, and rubber bushing construction to support consistent suspension movement and secure ball joint operation.

For 2005-2006 Honda Odyssey front left lower applications, X17CJ0100 provides a direct replacement format that helps maintain alignment and suspension articulation. The assembly is pre-greased, includes the ball joint and related retaining components, and does not use a grease fitting or lock nut.

Common Problems This Part Can Address

• Clunking or knocking from the front suspension
• Excessive play in the lower control arm or ball joint
• Uneven tire wear caused by worn suspension joints
• Loose or unstable steering feel
• Suspension noise over bumps and rough roads

Installation Notes and Tips

Install X17CJ0100 on the front left lower position only for the listed Honda Odyssey applications. Verify stud thread size, mounting style, and alignment settings before installation. Because the ball joint is press-in, proper service tools are required for removal and installation.

After installation, a professional wheel alignment is recommended to confirm suspension geometry and steering wheel position. Part number X17CJ0100 should be matched to the vehicle’s year, make, model, and position before service begins.

Quality Assurance

Suspensia parts are produced in IATF 16949 certified factories, with manufacturing backed by ISC Industries’ OE supply experience. This part cross-references Monroe Shocks & Struts RK620505 for the same application.