Suspensia X17CJ0950 Suspension Control Arm and Ball Joint Assembly - Front Left Lower

Suspension Control Arm for Honda Fit

Suspensia X17CJ0950 is a front left lower suspension control arm and ball joint assembly for select 2015-2020 Honda Fit models. Built from steel with rubber bushings and a pre-greased ball joint, it is made for direct replacement service on the front suspension.

Key Features

• Fits 2015-2020 Honda Fit, front left lower
• Suspension control arm and ball joint assembly
• Steel housing and steel arm construction
• Pre-greased ball joint with dust boot included
• Ball joint included with press-in mounting type
• Rubber bushings and rubber dust boot
• Castle nut and cotter pin included
• Stud thread size: M12 x 1.25
• Part number: X17CJ0950

Detailed Description

Suspensia X17CJ0950 is a front left lower control arm assembly for the Honda Fit, combining the arm, ball joint, bushings, and dust boot in one service part. The steel construction supports consistent suspension geometry, while the pre-greased, threaded ball joint is supplied with a rubber boot for added protection. This assembly is a practical choice for Honda Fit front suspension repair where the original control arm and ball joint need replacement.

Suspensia is manufactured in Turkey in IATF16949 certified factories under ISC Industries, a supplier to OE Tier 1 and Tier 2 programs for brands including Ford, Fiat/Chrysler, Volkswagen Group, and Renault/Nissan. Part number X17CJ0950 also cross-references 51350T5AJ01 and 521202 for the same application.

What It Helps Fix

• Front-end clunking or knocking from a worn lower control arm
• Loose or unstable steering feel on the Honda Fit
• Uneven tire wear caused by suspension wear
• Excess play from a worn ball joint or bushings
• Noise from a damaged dust boot or deteriorated joint seal

Installation Notes

Fits 2015-2020 Honda Fit, front left lower. Verify the stud thread size is M12 x 1.25 before installation and confirm alignment after replacement. The ball joint is press-in and the assembly includes a castle nut and cotter pin; the grease fitting is not included and the unit is not greaseable.

Quality Assurance

Suspensia parts are produced in IATF16949 certified factories in Turkey, with manufacturing backed by ISC Industries’ OE supply experience. X17CJ0950 is built to meet the demands of routine suspension service on the Honda Fit.