Suspensia X18CJ1525 Suspension Control Arm and Ball Joint Assembly - Front Left Lower

Suspension Control Arm Assembly for Hyundai Veloster

Restore front suspension geometry with this Suspensia suspension control arm and ball joint assembly, part number X18CJ1525. It is a direct OE-fit, OE-look replacement built for the front left lower position on the 2020-2021 Hyundai Veloster.

Key Features

• Fits 2020-2021 Hyundai Veloster, front left lower
• Suspension control arm and ball joint assembly
• Pre-greased for ready-to-install service
• Ball joint included with bolt-in mounting type
• Threaded ball joint stud with castle nut and cotter pin included
• Bushings included with black rubber construction
• Dust boot included with black rubber boot material
• Grease fitting not included; non-greaseable design
• Cross-reference: Hyundai OE part 54500J3AA0

Detailed Description

Suspensia X18CJ1525 is engineered as a suspension control arm and ball joint assembly for the front left lower side of the Hyundai Veloster. Built to OE or better quality standards, it follows the original fit and appearance expected for a direct replacement on 2020-2021 Hyundai Veloster applications. The assembly includes the ball joint, bushings, dust boot, castle nut, and cotter pin, with a pre-greased, non-greaseable design for straightforward service replacement.

Suspensia manufactures chassis components in a highly automated OE production facility in Turkiye and backs its process with IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 certifications. For buyers searching for a front left lower control arm for Hyundai Veloster 2020-2021, or a direct-fit suspension control arm assembly part number X18CJ1525, this component is built to match the original application requirements.

Common Problems This Part Can Address

• Excessive front-end looseness or wandering
• Clunking or knocking from the front suspension
• Worn ball joint movement
• Cracked or deteriorated control arm bushings
• Uneven tire wear caused by suspension wear

Installation Notes and Tips

Install on the front left lower position only for the listed Hyundai Veloster applications. Verify alignment after replacement, since control arm service can affect camber and toe settings. Confirm the ball joint stud, castle nut, and cotter pin are seated correctly during installation, and inspect adjacent suspension components for wear before returning the vehicle to service.

Quality Assurance

Suspensia positions this chassis part as an OE-fit replacement manufactured to OE or better quality standards. The brand’s production process is supported by multiple international quality and environmental certifications, including IATF 16949:2016 and ISO 9001:2015, reflecting controlled manufacturing and assembly practices for suspension components.