Suspensia X18CJ1600 Suspension Control Arm and Ball Joint Assembly - Rear Right Upper Rearward

Suspension Control Arm Assembly for Rear Right Upper Rearward

Suspensia X18CJ1600 is a suspension control arm and ball joint assembly built for direct OE fit and OE look. It is engineered for the rear right upper rearward position on select Genesis and Hyundai models, with the bushings, dust boot, and locking nut included for a complete replacement assembly.

Key Features

• Direct-fit suspension control arm and ball joint assembly
• Rear right upper rearward position
• Includes bushings and dust boot
• Rubber boot and rubber bushing materials
• Machined ball joint mounting type with threaded stud
• Black bushing and boot color
• Locking nut included; castle nut and cotter pin not included
• Non-greaseable design with no grease fitting

Detailed Product Overview

The Suspensia X18CJ1600 is manufactured to OE or better quality standards for chassis applications and is built in a fully automated facility using OE-fit production methods. It uses a composite bearing material, rubber dust boot, and rubber bushings to support consistent suspension operation in the rear suspension assembly. This part cross-references Delphi TC6935 for the same application. Compatible with 2017-2020 Genesis G80, rear right upper rearward, and 2015-2016 Hyundai Genesis, rear right upper rearward. The X18CJ1600 is a practical replacement when servicing the rear suspension on Genesis G80 and Hyundai Genesis models.

Common Repair Applications

• Replacing a worn or noisy rear suspension control arm assembly
• Addressing looseness or play in the rear right upper rearward suspension
• Restoring proper rear wheel control and suspension geometry
• Correcting clunking or knocking from worn ball joint or bushings
• Servicing a damaged dust boot or deteriorated rubber components

Installation Notes and Tips

Verify vehicle fitment by year, make, model, and rear right upper rearward position before installation. Because this assembly is non-greaseable and does not include a grease fitting, it is installed as a sealed component. Confirm stud thread size M14 and use the included locking nut during installation. Professional alignment is recommended after suspension component replacement.

Quality Assurance

Suspensia manufactures chassis parts in an IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 certified facility. The brand states its parts are produced to OE fit and OE look standards for North American aftermarket applications.