Suspensia X18TE0740 Steering Tie Rod End - Front Left Outer

Suspensia Outer Tie Rod End for Hyundai and Kia

The Suspensia X18TE0740 is an outside steering tie rod end for the front left outer position on select Hyundai and Kia vehicles. It is built with a steel housing, steel bearing material, and a pre-greased design for direct replacement service.

Key Features

• Part number: X18TE0740
• Outside steering tie rod end
• Front left outer position
• Pre-greased for service-ready installation
• Steel housing with steel bearing material
• Rubber dust boot with neoprene dust boot material
• Dust boot included
• Cotter pin and washers included
• Threaded ball joint stud type
• Female end 2 thread gender
• Non-greaseable design

Detailed Description

Suspensia X18TE0740 is an OE-style steering tie rod end for the front left outer side of the steering linkage. It is compatible with 2019-2024 Hyundai Nexo, 2020-2023 Kia Telluride, 2019-2020 Hyundai Santa Fe, and 2019 Hyundai Santa Fe XL. This part cross-references 56820M5000 for the same application. Suspensia is manufactured in Turkey in IATF16949 certified factories, with brand ownership under ISC Industries, a supplier to major OE and Tier 1 programs.

Common Repair Uses

• Restores steering response when the outer tie rod end is worn
• Addresses looseness or play in the front left steering linkage
• Helps correct clunking or knocking from the front suspension area
• Supports proper toe alignment after steering component replacement
• Replaces a damaged dust boot or corroded tie rod end assembly

Installation Notes and Tips

Verify front left outer fitment before installation on the Hyundai Nexo, Kia Telluride, Hyundai Santa Fe, or Hyundai Santa Fe XL. Use the included cotter pin and washers during assembly, and inspect the mating steering components and alignment settings after replacement. Because this is a non-greaseable tie rod end, no grease fitting is provided.

Quality Assurance

Suspensia parts are produced in IATF16949 certified factories in Turkey, reflecting controlled manufacturing processes for steering and suspension components. The pre-greased construction and included dust boot support consistent service replacement on the specified applications.