Suspensia X22TE0380 Steering Tie Rod End - Front Right Outer

Front Right Outer Tie Rod End for Grand Cherokee

Suspensia X22TE0380 is an outside steering tie rod end built for direct OE fit and OE look. It is compatible with 1999-2004 Jeep Grand Cherokee front right outer applications and is supplied pre-greased for service-ready installation.

• Fits 1999-2004 Jeep Grand Cherokee, front right outer
• Outside tie rod end with threaded ball joint stud
• Steel housing with e-coated finish for added corrosion resistance
• Pre-greased design with grease fitting included
• Dust boot included; rubber boot material with neoprene dust boot material
• Castle nut and cotter pin included
• Greaseable construction with steel bearing material
• Part number: X22TE0380

Product Details

The Suspensia X22TE0380 steering tie rod end is engineered for the front right outer position on the Jeep Grand Cherokee from 1999 through 2004. It is manufactured in an OE-focused facility using automated production processes and built to match original fit and appearance requirements for steering service work. This part cross-references MOOG Chassis Products ES3472 and Delphi TA2191 for the same application.

For buyers searching for a 1999-2004 Jeep Grand Cherokee front right outer tie rod end, X22TE0380 provides a direct replacement option with the key service features needed for steering linkage repair. The steel housing, threaded stud, and greaseable design support routine maintenance, while the included dust boot helps protect the joint from road contamination.

Common Repair Uses

• Corrects looseness or play in the front steering linkage
• Addresses uneven tire wear caused by worn steering components
• Helps restore steering response and alignment stability
• Replaces a damaged or corroded outer tie rod end
• Supports repair of steering noise or clunking at the front right outer position

Installation Notes

Install on the front right outer steering position only for the listed Jeep Grand Cherokee applications. After replacement, a professional wheel alignment is recommended to verify steering geometry and tire wear settings. Confirm thread engagement and torque specifications during installation, and inspect the adjacent steering components for wear before returning the vehicle to service.

Quality Assurance

Suspensia manufactures chassis parts to OE or better quality standards in an IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 certified facility.