Suspensia X22TE1003 Steering Tie Rod End - Front Right Outer

Overview

The Suspensia X22TE1003 steering tie rod end is an OE-fit replacement for select Jeep steering applications. It is built with a steel housing, pre-greased construction, and a sealed dust boot to support precise steering linkage performance.

Fits 2018-2024 Jeep Wrangler, front right outer. Fits 2021-2023 Jeep Gladiator, front right outer. This part cross-references Mopar 68258761AE and Dorman OE Solutions 544-700 for the same application.

Key Features

• OE direct fit and OE look for straightforward replacement.
• Pre-greased design with no grease fitting for low-maintenance service.
• Steel housing with steel bearing material for durable steering linkage construction.
• Rubber and neoprene dust boot helps seal the joint from road contamination.
• Threaded ball joint stud with locking nut included.
• Outside tie rod end configuration for steering linkage service.

Product Details

Suspensia manufactures chassis parts to OE or better quality standards for the North American aftermarket, and the X22TE1003 follows that approach with direct OE fit and OE-style appearance. The design uses a threaded stud, female end thread, and a sealed boot assembly to support consistent steering response in Jeep Wrangler and Jeep Gladiator applications. The part number X22TE1003 is also referenced by Mopar 68258761AE and Dorman OE Solutions 544-700.

Common Replacement Issues

• Loose or imprecise steering feel from a worn outer tie rod end.
• Clunking or play in the steering linkage.
• Boot damage that exposes the joint to dirt and moisture.
• Uneven steering response caused by joint wear.

Installation Notes

Verify fitment by year, model, and front right outer position before installation. The part is pre-greased and does not use a grease fitting, so service procedures should follow the vehicle’s steering linkage requirements. After replacement, a wheel alignment is recommended to restore steering geometry.

Quality Assurance

Suspensia states that its chassis parts are manufactured in a fully automated OE facility in Turkiye and produced under IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 certified systems. Part number X22TE1003 is built to OE-fit standards for consistent replacement quality.