Suspensia X30CJ1506 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

Front Right Lower Control Arm Assembly

Suspensia X30CJ1506 is a front right lower suspension control arm and ball joint assembly built for direct OE fit and OE look. It is engineered for select Toyota RAV4 and Lexus NX applications, with steel construction, a pre-greased design, and a bolt-in ball joint for straightforward replacement service.

Compatible with 2019-2024 Toyota RAV4, 2021-2024 Toyota RAV4 Prime, and 2022-2024 Lexus NX250, NX350, NX350h, and NX450h+ in the front right lower position. The X30CJ1506 is built to match the original mounting layout and restore proper suspension geometry.

• Steel housing and steel construction for durable suspension service
• Pre-greased assembly with rubber dust boot and black rubber bushings
• Ball joint included with threaded stud type and bolt-in mounting design
• Castle nut, cotter pin, bushings, and dust boot included
• Direct OE fit and OE look for the front right lower position
• Stud thread size: M14 x 1.5; wrench size: 17 mm

Detailed Product Overview

Suspensia X30CJ1506 is a suspension control arm and ball joint assembly made for the front right lower corner of the chassis. It uses a steel housing, rubber bushings, a rubber dust boot, and a plastic bearing material to support consistent articulation and alignment control. The assembly is pre-greased and does not require a grease fitting, and the ball joint uses a threaded stud with bolt-in mounting for a factory-style replacement. This part number is a direct-fit solution for Toyota RAV4 and Lexus NX models listed in the fitment data, including 2019-2024 Toyota RAV4, 2021-2024 Toyota RAV4 Prime, and 2022-2024 Lexus NX250, NX350, NX350h, and NX450h+.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What This Part Helps Address

• Clunking or looseness from a worn lower control arm assembly
• Uneven tire wear caused by suspension wear or alignment shift
• Steering pull or unstable front-end response
• Excess play from a worn ball joint or deteriorated bushings
• Noise over bumps from damaged suspension pivot components

Installation Notes and Tips

Install X30CJ1506 on the front right lower position only for the listed vehicles. Verify the M14 x 1.5 stud thread size, use the included castle nut and cotter pin where specified, and complete a wheel alignment after installation. Because this assembly is pre-greased and not greaseable, no grease fitting service is required.

Quality Assurance

Suspensia manufactures OE or better quality chassis parts in a fully automated OE production environment. The brand’s facility operates under IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 certifications, supporting consistent manufacturing control for replacement chassis components such as X30CJ1506.