Suspensia X30TE0870 Steering Tie Rod End - Front Left Outer

Suspensia X30TE0870 Steering Tie Rod End

Suspensia X30TE0870 is an outside steering tie rod end built for direct OE fit and OE appearance. It is pre-greased, e-coated, and supplied with a dust boot, making it a practical replacement for worn steering linkage on select Lexus applications.

Compatible with 1992-1994 Lexus SC300 and 1992-1994 Lexus SC400, front left outer. This part cross-references Dorman OE Solutions 544-313 for the same application.

Key Features

• Outside steering tie rod end for front left outer placement
• Direct OE fit and OE look for straightforward replacement
• Pre-greased design for initial service readiness
• E-coated steel housing for added corrosion resistance
• Steel bearing material with threaded ball joint stud
• Rubber dust boot with neoprene dust boot material and black boot color
• Locking nut included; grease fitting, castle nut, cotter pin, washers, and adjusting sleeve not included

Detailed Description

Suspensia X30TE0870 is engineered as an OE-style steering tie rod end for the front left outer position on 1992-1994 Lexus SC300 and Lexus SC400 models. The steel housing, threaded stud, and pre-greased construction support a clean replacement for a worn outer tie rod end, while the e-coated finish and protective boot help maintain durability in everyday driving conditions. The part number X30TE0870 is also useful when cross-checking catalog listings for the same Lexus steering application.

Common Problems This Part Can Address

• Excessive steering play from a worn outer tie rod end
• Clunking or looseness in the front steering linkage
• Uneven tire wear caused by steering component wear
• Steering wheel wander or poor on-center feel
• Boot damage that exposes the joint to contamination

Installation Notes and Tips

Install on the front left outer steering position only for the listed Lexus SC300 and SC400 applications. Verify thread engagement, torque fasteners to factory specifications, and perform a professional wheel alignment after replacement. The locking nut is included; castle nut, cotter pin, grease fitting, washers, and adjusting sleeve are not included.

Quality Assurance

Suspensia manufactures chassis parts in a fully automated OE manufacturing facility in Turkiye and states that its operations are certified to IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 standards. The part number X30TE0870 is produced to OE or better quality expectations for the North American aftermarket.