Suspensia X39CJ1085 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

Suspension Control Arm for Porsche 911

Suspensia X39CJ1085 is a front right lower suspension control arm and ball joint assembly for select 2002-2005 Porsche 911 models. Built with a cast aluminum arm, pre-greased construction, and included bushings and dust boot, it is made for direct OE fit and OE appearance in the front suspension.

Key Features

• Fits 2002-2005 Porsche 911, front right lower
• Suspensia X39CJ1085 suspension control arm and ball joint assembly
• Cast aluminum construction for OE-style fitment
• Pre-greased assembly with rubber dust boot
• Black rubber bushings included
• Lock nut included; M12 x 1.5 stud thread size
• 18 mm wrench size

Detailed Description

This Suspensia control arm assembly is engineered for the front right lower position on the Porsche 911 from 2002 through 2005. The X39CJ1085 combines the control arm and ball joint into one service part, helping restore proper suspension geometry and steering response when the original component is worn. It uses cast aluminum construction, black rubber bushings, and a rubber dust boot, with the assembly pre-greased for service-ready installation. Suspensia manufactures chassis parts to OE or better quality standards in an automated facility and builds to direct OE fit and OE look requirements.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Repair Applications

• Front-end clunking or looseness from a worn lower control arm
• Uneven tire wear caused by suspension wear at the front right corner
• Steering wander or reduced road feel on a Porsche 911
• Ball joint play in the front right lower suspension assembly
• Cracked or deteriorated bushings in the lower control arm

Installation Notes and Tips

Install on 2002-2005 Porsche 911 models in the front right lower position only. Verify stud thread size, mounting points, and alignment settings before final tightening. Because this assembly includes bushings and a dust boot, inspect adjacent suspension components and complete a wheel alignment after installation.

Quality Assurance

Suspensia chassis parts are produced in an OE manufacturing facility with automated assembly and certified quality, environmental, and safety management systems. The brand states its parts are built for direct OE fit and OE look for North American aftermarket service.