Suspensia X39TE0988 Steering Tie Rod End - Front Left

Suspensia X39TE0988 Front Left Tie Rod End

Suspensia X39TE0988 is a front left outside steering tie rod end built for direct OE fit and OE appearance. It is engineered for the Bentley Continental, Bentley Flying Spur, and Porsche Panamera applications listed below, with pre-greased construction and a sealed rubber dust boot for service-ready steering performance.

• Forged steel housing for strength and durability
• Pre-greased design for initial service readiness
• Black rubber dust boot included to help protect the joint
• Outside tie rod end configuration
• Threaded ball joint stud with female end 2 thread gender
• Locking nut included
• Non-greaseable design
• Composite bearing material
• Direct OE fit and OE look

Vehicle Fitment

• Fits 2019-2023 Bentley Continental, front left.
• Fits 2020-2023 Bentley Flying Spur, front left.
• Fits 2017-2023 Porsche Panamera, front left.

Detailed Description

This steering tie rod end is part of Suspensia’s chassis line, produced in a fully automated OE manufacturing environment and built to meet OE or better quality expectations for the North American aftermarket. The X39TE0988 uses forged steel construction, an aluminum stud material, and a rubber boot to support a clean, sealed steering connection at the front left outside position. For shoppers comparing Bentley Continental tie rod end, Bentley Flying Spur steering parts, or Porsche Panamera front left steering components, this part number provides a direct replacement format that matches the listed applications.

This part cross-references Dorman - OE Solutions 544-055 for the same application.

What It Is Used For

• Replacing a worn front left outer tie rod end
• Restoring steering response and wheel control
• Addressing looseness or play in the steering linkage
• Correcting uneven tire wear caused by steering end wear
• Replacing a damaged dust boot or sealed joint assembly

Installation Notes and Tips

Confirm front left application before installation and inspect the steering linkage, adjusting sleeve, and related components for wear. Because this tie rod end is non-greaseable and pre-greased, it is installed as a sealed unit. A professional alignment is recommended after replacement to restore proper steering geometry.

Quality Assurance

Suspensia manufactures chassis parts in an IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 certified facility with OE-fit production standards and high-volume automated assembly.