Suspensia X50CJ1181 Suspension Control Arm and Ball Joint Assembly - Front Left Upper

Suspension Control Arm for Tacoma

Restore front suspension geometry with this Suspensia suspension control arm and ball joint assembly, part number X50CJ1181. It is built as a direct OE-fit replacement for the front left upper position on 1995-2004 Toyota Tacoma models, with pre-greased components and a bolt-in ball joint for straightforward service replacement.

Key Features

• Direct OE fit and OE look for the front left upper suspension position
• Includes ball joint, bushings, dust boot, castle nut, and cotter pin
• Pre-greased assembly with a non-greaseable design
• Ball joint uses a bolt-in mounting type with a threaded stud
• Rubber bushings and rubber dust boot for consistent isolation
• Black bushing and boot finish

Detailed Description

Suspensia X50CJ1181 is a suspension control arm and ball joint assembly engineered for 1995-2004 Toyota Tacoma front left upper applications. It is manufactured to OE or better quality standards in a fully automated facility and built to match original fit and appearance. For Tacoma owners replacing worn front suspension components, this assembly provides the control arm, ball joint, bushings, and dust boot in one service part. This part cross-references MOOG Chassis Products RK623055 and Delphi TC7142 for the same application.

Common Problems It Can Address

• Front-end clunking or looseness from worn ball joint or bushings
• Uneven tire wear caused by suspension play
• Steering wander or reduced directional stability
• Noise over bumps from deteriorated rubber components
• Restoration of front left upper suspension alignment points

Installation Notes

Fits 1995-2004 Toyota Tacoma, front left upper. Verify the mounting style, stud type, and position before installation. Because the assembly is pre-greased and not greaseable, no grease fitting service is required. Always inspect related suspension hardware and perform a professional alignment after replacement.

Quality Assurance

Suspensia manufactures chassis parts to OE-fit standards in an IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 certified facility. X50CJ1181 is produced with controlled assembly processes for consistent fit and finish across Toyota Tacoma front suspension service applications.