Suspensia X52LA0430 Suspension Control Arm - Rear Lower

Rear Lower Control Arm for Volkswagen and Audi

Restore rear suspension geometry with the Suspensia X52LA0430 suspension control arm. This rear lower control arm is built as a direct OE-fit replacement with OE-style dimensions and rubber bushings for select Volkswagen and Audi applications.

Fits 2019-2023 Volkswagen Jetta, rear lower. Fits 2022-2023 Volkswagen Taos, rear lower. Fits 2015-2021 Volkswagen Golf, rear lower. Fits 2015-2021 Volkswagen GTI, rear lower. Fits 2015-2020 Audi S3, rear lower. Fits 2015-2019 Audi A3, rear lower. Fits 2015-2019 Audi A3 Quattro, rear lower. Fits 2015-2019 Volkswagen e-Golf, rear lower. Fits 2017-2019 Volkswagen Golf Alltrack, rear lower. Fits 2015-2019 Volkswagen Golf SportWagen, rear lower. Fits 2016-2018 Audi TT Quattro, rear lower. Fits 2015-2016 Volkswagen Golf R, rear lower. Fits 2018 Volkswagen Golf R, rear lower.

• Suspensia part number X52LA0430
• Rear lower suspension control arm
• Direct OE fit and OE look
• Black rubber bushings included
• Pre-greased: No
• Greaseable: No
• Ball joint not included
• Dust boot not included
• Castle nut, locking nut, cotter pin, and grease fitting not included

Detailed Product Overview

The Suspensia X52LA0430 is a suspension control arm for the rear lower position on select Volkswagen and Audi models. It uses rubber bushings and a regular-grade construction to match the original mounting style and suspension layout. Suspensia manufactures chassis parts to OE or better quality standards in a fully automated facility, with direct-fit dimensions intended to align with factory suspension points. This part cross-references Delphi TC6880 and Dorman - OE Solutions 527-092 for the same application.

Common Repair Applications

• Rear suspension clunking or looseness from worn control arm bushings
• Uneven rear tire wear caused by suspension geometry changes
• Excessive rear-end movement over bumps or during cornering
• Failed OE-style arm replacement on Volkswagen Jetta, Golf, GTI, Taos, and Audi A3/S3 platforms

Installation Notes and Tips

Confirm vehicle fitment by year, make, model, and rear lower position before installation. Because this arm is not pre-greased and does not include a ball joint, dust boot, or mounting hardware, transfer or source any required components separately as needed for the specific vehicle setup. Final tightening should be performed at normal ride height to help avoid premature bushing preload.

Quality Assurance

Suspensia chassis parts are produced in an IATF 16949:2016, ISO 9001:2015, ISO 14001:2015, ISO 45001:2018, and ISO 50001:2018 certified facility with automated assembly and OE-style fitment standards. Part number X52LA0430 is manufactured for consistent dimensional accuracy and repeatable suspension service on the listed applications.