TC Remanufacturing 792 Automatic Transmission Torque Converter

Automatic Transmission Torque Converter for Dodge and Jeep

TC Remanufacturing 792 is an automatic transmission torque converter built for specific Dodge and Jeep applications. It features a 11.000-inch converter diameter, 10.000 bolt circle, lock-up design, and a 2050 stall rating for the listed vehicles.

Key Features

• Part number: 792
• Automatic transmission torque converter
• Lock-up converter type
• 11.000-inch converter diameter
• 10.000 bolt circle
• 2050 stall
• 26 spline count
• Flats hub type
• Thin mounting type
• 1.810 pilot diameter
• Ring gear included with 130 wide tooth count
• Converter code: Red Sticker

Product Details

This TC Remanufacturing torque converter is specified for Dodge Ram 1500, Dodge Durango, Dodge Dakota, Dodge Ram 1500 Van, Dodge B1500, Dodge B2500, and Jeep Grand Cherokee applications listed below. The lock-up design supports direct drivetrain coupling under cruise conditions, while the 2050 stall specification and 26 spline configuration match the transmission requirements for the covered vehicles. If you are replacing a worn or failing converter on a Dodge Ram 1500 or Jeep Grand Cherokee, part number 792 provides the listed hard-part dimensions needed for proper fitment.

Vehicle Fitment

• Fits 1996-2001 Dodge Ram 1500, N/A
• Fits 1998-2000 Dodge Durango, N/A
• Fits 1996-1999 Dodge Dakota, N/A
• Fits 1999 Dodge Ram 1500 Van, N/A
• Fits 1998 Dodge B1500, N/A
• Fits 1996-1998 Jeep Grand Cherokee, N/A
• Fits 1995-1997 Dodge B2500, N/A

Common Replacement Reasons

• Transmission shudder or slip during lock-up operation
• Incorrect stall speed after a converter failure
• Damaged hub, spline, or pilot interface
• Noise or vibration from a worn torque converter assembly
• Replacement during transmission rebuild or overhaul

Installation Notes

Verify the converter code, spline count, pilot diameter, bolt circle, and ring gear details against the original unit before installation. Confirm transmission compatibility and inspect the flexplate, cooler lines, and front pump condition during replacement. Proper fluid fill and initial startup checks are important after installation of TC Remanufacturing 792.

Quality Assurance

TC Remanufacturing supplies remanufactured transmission hard parts for service replacement applications. This part is identified by part number 792 and the listed dimensional specifications for the covered Dodge and Jeep vehicles.