TechPro KI1144106C Bumper Cover Molding - Rear

Rear Center Bumper Cover Molding for Kia Seltos

This TechPro bumper cover molding is built for the rear center position on the 2021-2023 Kia Seltos. It is made to install with factory-style precision and restore the vehicle’s exterior appearance with a clean, seamless finish.

• Fits 2021-2023 Kia Seltos, rear center
• Factory-style precision for accurate body panel alignment
• High-quality materials for durability and lasting performance
• Helps restore the rear bumper area after wear or damage
• Part number: KI1144106C

Detailed Product Overview

TechPro KI1144106C is a bumper cover molding for the rear center section of the Kia Seltos. It is sized at 58.9 inches long, 6.7 inches wide, and 4.3 inches high, with a 2 lb weight, giving it the dimensions needed for a direct body repair application. For drivers searching for a rear center bumper cover molding for 2021-2023 Kia Seltos, KI1144106C provides an OE-style replacement solution that supports a clean exterior finish.

This part cross-references Kia OE number 86696Q5010 for the same application.

Common Repair Uses

• Replacing a cracked or worn rear bumper cover molding
• Restoring the rear center appearance after minor impact damage
• Correcting faded or damaged exterior trim on a Kia Seltos
• Addressing missing or mismatched bumper molding during body repair

Installation Notes

Install on the rear center bumper area of the 2021-2023 Kia Seltos. Verify part orientation and body-panel alignment before final installation to ensure a factory-style fit. Compare the existing molding and OE reference before painting or finishing, if applicable to your repair process.

Quality Assurance

TechPro builds this bumper cover molding with high-quality materials to support durability and consistent performance in everyday use. The part is intended to restore the vehicle’s appearance with a seamless look while matching the factory-style application for the Kia Seltos.