Timken 1180S Wheel Seal - Front, Front Inner or Rear

Timken 1180S Wheel Seal for Driveline Service

The Timken 1180S wheel seal is built for axle and hub sealing applications where lubricant retention and contamination control matter. It uses an S-Nitrile sealing material with a reinforced outer case and a ribbed inner diameter to help seat against minor spindle imperfections.

Compatible with select Acura, Geo, Chevrolet, and Toyota applications, including Toyota Corolla rear wheel seal service and Acura RL front inner applications, the 1180S is sized for precise housing and shaft dimensions. This Timken wheel seal is a direct-fit service part for common driveline and axle maintenance.

Key Features

• Timken 1180S wheel seal for driveline and axle sealing service
• S-Nitrile material for sealing performance in lubricant applications
• Reinforced outer case helps resist installation damage
• Ribbed rubber inner diameter helps seal minor spindle imperfections
• Internal contamination exclusion system helps block debris entry
• Vent holes promote lubricant flow around the seal lip to reduce heat build-up
• Dimensions: 2.172 in. outside diameter, 1.614 in. shaft diameter, 2.165 in. housing bore, 0.236 in. width

Detailed Description

The Timken 1180S is a wheel seal designed for axle ends and hub assemblies that need dependable lubricant control. Its precision sealing design helps keep grease or oil inside the assembly while limiting the entry of dirt and road contamination. The reinforced outer case adds durability during installation, and the ribbed inner diameter supports a tighter seal on shafts with minor surface variation. This part cross-references Gates 1180 for the same application.

Use the 1180S when servicing compatible front inner or rear wheel seal locations on vehicles such as the 1997-2001 Acura RL, 1994-1995 Acura Legend, 1989-1992 Geo Prizm, 1984-1992 Toyota Corolla, 1985-1989 Toyota MR2, 1985-1988 Chevrolet Nova, and 1983-1987 Toyota Tercel. Timken 1180S is a practical choice for restoring sealing performance in these driveline and axle applications.

What It Helps Fix

• Gear oil or grease leakage at the wheel end
• Contamination entering the hub or axle area
• Seal wear caused by heat and lubricant breakdown
• Minor spindle surface imperfections affecting seal contact
• Noise or service issues related to low lubricant retention

Installation Notes and Tips

Confirm housing bore, shaft diameter, outside diameter, and width before installation. Clean the spindle, hub, and seal bore thoroughly, and inspect for scoring or corrosion that could affect sealing. Press the seal in evenly to avoid distorting the reinforced case or damaging the sealing lip.

For fitment-specific service, verify the vehicle position before ordering. This part fits 2001-1997 Acura RL, front inner; 1995-1994 Acura Legend, front inner; 1992-1989 Geo Prizm, rear; 1992-1984 Toyota Corolla, rear; 1989-1985 Toyota MR2, front; 1988-1985 Chevrolet Nova, rear; and 1987-1983 Toyota Tercel, rear.

Quality Assurance

Timken manufactures sealing components with precision-focused designs for driveline service. The 1180S is engineered to support reliable lubricant retention and contamination exclusion in compatible wheel seal applications.