Timken 1936 Wheel Seal - Front Inner

Timken 1936 Wheel Seal for Honda Front Inner

Timken 1936 is a wheel seal built for front inner applications on select Honda models. It uses S-Nitrile material and a precision sealing design to help retain lubricant while keeping road debris and contaminants out of the hub area.

Compatible With 1985 Honda Accord, front inner, and 1985-1987 Honda Prelude, front inner. This part cross-references National (e.g., 1936) for the same application.

Key Features

• S-Nitrile construction for sealing performance and durability
• Reinforced outer case helps resist installation damage
• Ribbed rubber inner diameter helps seal minor spindle imperfections and improve spindle seating
• Internal contamination exclusion system helps block debris that can lead to leakage
• Vent holes promote lubricant flow around the seal lip to reduce heat buildup
• Dimensions: 0.236 in. width, 2.531 in. outside diameter, 1.929 in. shaft diameter, 2.520 in. housing bore

Detailed Description

Timken 1936 is engineered as a wheel seal for the front inner position on 1985 Honda Accord and 1985-1987 Honda Prelude applications. The seal’s precision design supports lubricant retention at the hub while helping prevent contamination from entering the sealing area. Its reinforced outer case adds durability during installation, and the ribbed inner diameter is shaped to seat against minor spindle irregularities for a more consistent seal. Timken 1936 is a direct-fit service part for drivers and technicians replacing a worn or leaking wheel seal on these Honda models.

What It Helps Address

• Wheel-end grease or oil leakage at the hub
• Contamination entering the spindle or bearing area
• Seal wear from heat buildup around the lip
• Poor sealing on spindles with minor surface imperfections
• Damage caused during seal installation

Installation Notes and Tips

Verify the front inner position and confirm the listed dimensions before installation. Clean the spindle and housing bore thoroughly, inspect for scoring or wear, and seat the seal evenly to avoid distortion. For best results, replace any damaged bearing components and check the sealing surface for proper finish before assembly.

Quality Assurance

Timken manufactures this wheel seal with a contamination-exclusion design and heat-management features to support consistent sealing performance in wheel-end service.