Timken 224560 Manual Transmission Output Shaft Seal - Rear

Manual Transmission Output Shaft Seal for Mitsubishi, Porsche, Toyota

Timken 224560 is a manual transmission output shaft seal built for precise lubricant control at the transmission housing. It uses an S-Nitrile sealing material, a reinforced outer case, and a ribbed inner diameter to help seat against minor shaft imperfections while keeping gear oil where it belongs.

Compatible with select Mitsubishi Montero, Mitsubishi Montero Sport, Mitsubishi Mighty Max, Porsche 911, Dodge Ram 50, Dodge D50, and Toyota Pickup applications, Timken 224560 is a direct-fit sealing solution for rear output shaft service on many manual transmission setups.

• S-Nitrile construction for sealing performance in transmission service
• Outside diameter: 2.688 in. / 68.28 mm
• Shaft diameter: 1.772 in. / 45.00 mm
• Housing bore: 2.677 in. / 68.00 mm
• Width: 0.335 in. / 8.50 mm
• Reinforced outer case helps resist installation damage
• Ribbed rubber inner diameter helps seal minor spindle imperfections
• Internal contamination exclusion system helps block debris entry
• Vent holes promote lubricant flow around the seal lip to reduce heat build-up

Detailed Application and Fitment

This Timken 224560 manual transmission output shaft seal is used to retain lubricant at the output shaft while helping keep dirt and debris out of the transmission. It is a practical replacement for rear-position service on 2004 Mitsubishi Montero, 2001-2002 Mitsubishi Montero, 2000-2003 Mitsubishi Montero, 1990-1997 Mitsubishi Montero, 2000-2003 Mitsubishi Montero Sport, 1997 Mitsubishi Montero Sport, 1990-1994 Mitsubishi Mighty Max, 1983-1989 Mitsubishi Mighty Max, 1983-1989 Mitsubishi Montero, 1987-1994 Porsche 911, 1980-1986 Porsche 911, 1965-1969 Porsche 911, 1983-1984 Dodge Ram 50, 1982 Dodge D50, 1978-1979 Porsche 911, 1970-1976 Porsche 911, and 1972-1977 Toyota Pickup. This part cross-references BBB Industries 17766 and Dynomax 17758 for the same application.

What This Seal Helps Address

• Transmission fluid seepage at the output shaft
• Contamination entering the manual transmission housing
• Leakage caused by minor shaft wear or surface imperfections
• Heat-related seal wear from poor lubricant circulation
• Damage during seal installation on the housing bore

Installation Notes and Tips

Inspect the output shaft, housing bore, and surrounding sealing surface before installation. Clean the bore thoroughly, verify the seal dimensions match the application, and press the seal in evenly to avoid distortion. For Porsche 911, Mitsubishi Montero, Mitsubishi Mighty Max, and Toyota Pickup manual transmission service, confirm the transmission code and rear output seal location before ordering.

Quality Assurance

Timken designs its oil and grease seals with precision sealing features, reinforced construction, and contamination control details to support dependable transmission service. Part number 224560 is built to the listed dimensions and application coverage for accurate replacement selection.