Timken 225208 Wheel Seal - Rear Inner

Timken 225208 Wheel Seal Overview

Timken 225208 is a wheel seal built for driveline and axle service where reliable lubricant retention and contamination control matter. Its S-Nitrile construction, reinforced outer case, and ribbed inner diameter support a secure seal at the spindle and housing interface.

Compatible With wheel seal applications on axle assemblies that use a 2.047 in shaft diameter and 2.559 in housing bore, this Timken 225208 seal is a practical choice for service work on vehicles such as Honda Civic and Toyota Corolla where precise sealing dimensions are critical.

Key Features

• S-Nitrile sealing material for oil and grease resistance
• Outside diameter: 2.570 in (65.28 mm)
• Housing bore: 2.559 in (65.00 mm)
• Shaft diameter: 2.047 in (52.00 mm)
• Width: 0.354 in (9.00 mm)
• Reinforced outer case helps reduce installation damage
• Ribbed rubber inner diameter helps seal minor spindle imperfections
• Internal contamination exclusion system helps block debris entry
• Vent holes promote lubricant flow around the seal lip and reduce heat build-up

Detailed Description

Timken 225208 is engineered as a wheel seal for axle and hub sealing service. The seal’s precision design helps retain lubricant at the wheel end while limiting the entry of dirt and other contaminants that can lead to leakage and premature wear. The reinforced case improves handling during installation, while the ribbed inner diameter supports seating on slightly imperfect spindle surfaces. This part cross-references Four Seasons 20408 for the same application.

For technicians servicing Honda Civic or Toyota Corolla wheel-end components, Timken 225208 provides the dimensional accuracy needed for a proper seal interface. The vented design also helps move lubricant around the lip area, which supports cooler operation during use.

What It Helps Address

• Wheel-end lubricant leakage
• Contamination entering the seal area
• Seal damage during installation
• Poor sealing on minor spindle imperfections
• Heat build-up around the seal lip

Installation Notes and Tips

Verify shaft diameter, housing bore, outside diameter, and width before installation. Clean the spindle and bore thoroughly, and inspect for scoring, corrosion, or wear that could affect sealing performance. Press the seal in evenly to avoid distorting the outer case or damaging the lip. Confirm the seal seats fully and that the wheel-end components rotate smoothly after assembly.

Quality Assurance

Timken manufactures oil and grease seals with precision sealing designs focused on lubricant retention and contamination control. Timken 225208 is built to the listed dimensions and material specification for wheel seal service.