Timken 305L Manual Transmission Output Shaft Bearing - Front Rearward or Rear

Timken 305L Manual Transmission Bearing

The Timken 305L is a manual transmission output shaft bearing built for applications that need stable rotation, controlled noise, and consistent vibration performance. It follows ISO dimensional standards for direct replacement use in a range of manual gearbox applications, including Toyota Corolla, Nissan 210, and Chevrolet LUV fitments.

Key Features

• Deep groove ball bearing construction for manual transmission output shaft service
• Engineered for low noise and reduced vibration under proper lubrication
• Tight tolerances and refined surface finish support higher operating speeds
• ISO-standard dimensions for interchangeability with matching competitor bearings
• Available in Timken 305L form for direct application matching

Application Details

Use the Timken 305L when replacing a manual transmission output shaft bearing in vehicles such as the 1971-1987 Toyota Corolla, 1980-1982 Nissan 210, 1979-1982 Chevrolet LUV, and 1984-1987 Isuzu Trooper. This part also cross-references 6305NR and 6305NRJ for the same application. The 305L part number is also listed for additional manual transmission fitments across Nissan, Ford Fiesta, and Chevrolet Bel Air applications.

What It Helps Fix

• Transmission bearing noise from worn or rough bearing surfaces
• Excess vibration in the manual gearbox
• Loose or inconsistent shaft support
• Wear-related driveline harshness during operation
• Replacement needs for output shaft bearing service

Installation Notes

Confirm the transmission code, bearing dimensions, and position before installation. This bearing is listed for rear and front rearward positions depending on application, so match the vehicle and gearbox details exactly. Proper lubrication and clean assembly surfaces are important for bearing life and smooth operation.

Quality Assurance

Timken deep groove bearings are manufactured to rigorous worldwide quality standards and built to meet ISO dimensional requirements. The 305L is intended as a dimensionally interchangeable replacement where the listed fitment and bearing specifications match.