Timken 450067 Wheel Seal - Rear

Timken Wheel Seal 450067 Overview

Timken 450067 is a wheel seal for driveline and axle applications that helps retain lubricant and block road debris from entering the hub area. It is built with a reinforced outer case, a ribbed rubber inner diameter for better spindle seating, and vent holes that promote cooler seal operation.

Compatible With wheel seal applications on vehicles such as Honda Civic and Toyota Corolla where the listed part number matches the original seal specification. This part cross-references Bosch 15141 and Gates 18516 for the same application.

Key Features

• Precision sealing design helps control grease and oil loss at the wheel end
• Reinforced outer case resists installation damage and supports durability
• Ribbed rubber inner diameter helps seal minor spindle imperfections
• Internal contamination exclusion system helps keep debris out of the seal area
• Vent holes allow lubricant flow around the seal lip to reduce heat build-up

What This Wheel Seal Helps Address

• Grease or oil leakage at the wheel hub
• Contamination entering the spindle or bearing area
• Seal wear caused by heat build-up
• Poor sealing on slightly imperfect spindle surfaces
• Noise or service issues related to lubricant loss

Installation Notes

Verify the seal dimensions and OE part number before installation. Clean the spindle, hub bore, and sealing surface thoroughly, and inspect the bearing and spindle for wear or scoring. Proper seating is important for a reliable seal, especially on Honda Civic and Toyota Corolla wheel-end service where contamination control matters.

Quality Assurance

Timken designs oil and grease seals with precision sealing features for driveline and axle service. Part number 450067 is built to meet the demands of wheel-end sealing applications and is supported by Timken engineering standards.