Timken 470672 Wheel Seal - Front or Front Right

Timken Wheel Seal 470672

Timken 470672 is a wheel seal built for front axle and front right applications where reliable lubricant retention and contamination control matter. It is used on select BMW and Ford vehicles, including BMW 528i front and Ford F-150 front right Dana/Spicer 44 IFS applications.

Key Features

• Precision sealing design helps keep grease and oil inside the hub or axle assembly.
• Reinforced outer case resists installation damage and adds durability.
• Ribbed rubber inner diameter seals minor spindle imperfections and supports positive spindle seating.
• Internal contamination exclusion system blocks debris that can lead to leakage.
• Vent holes promote lubricant flow around the seal lip to reduce heat buildup.

Detailed Description

This Timken wheel seal is engineered for driveline and axle service where a dependable seal is critical to bearing and hub life. The 470672 part number is used across a wide range of front and front right fitments, including BMW 318ti, 328i, 328is, M3, Z3, 525i, 530i, and 528i front applications, plus Ford Aerostar, Explorer, Ranger, Bronco II, F-150, F-250, F-350, and F-250 HD configurations listed for the correct axle or transmission setup. This part cross-references National 470672 for the same application.

Common Problems This Seal Addresses

• Gear oil or grease leakage at the wheel end
• Contamination entering the hub or axle area
• Seal wear from spindle surface imperfections
• Heat buildup around the seal lip
• Reduced sealing performance after service or replacement

Installation Notes and Tips

Verify the vehicle year, make, model, position, and axle configuration before installation. Clean the spindle, hub bore, and sealing surface thoroughly, and inspect for scoring or wear that could affect seal seating. Proper alignment during installation is important to avoid damaging the seal lip or outer case.

Quality Assurance

Timken oil and grease seals use precision sealing designs and contamination exclusion features to support dependable service in driveline and axle applications.