Timken 710132 Manual Transmission Output Shaft Seal - Left or Right

Manual Transmission Output Shaft Seal for Nissan and Infiniti

Timken 710132 is a manual transmission output shaft seal built to retain lubricant and block contaminants at the transmission shaft. It is a direct-fit sealing component for select Nissan, Infiniti, and Chevrolet City Express applications, including right- and left-side positions where specified.

• Precision sealing design helps reduce lubricant escape
• Reinforced outer case resists installation damage and adds durability
• Ribbed rubber inner diameter helps seal minor spindle imperfections
• Internal contamination exclusion system helps keep debris out of the seal area
• Vent holes promote lubricant flow around the seal lip to reduce heat buildup
• Timken part number 710132 for manual transmission service

Detailed Product Information

Built for transmission sealing service, Timken 710132 helps maintain proper fluid retention at the output shaft while limiting the entry of dirt and other contaminants. The reinforced case supports a secure fit during installation, while the ribbed inner diameter is engineered to seat against small surface imperfections for consistent sealing performance. This seal is used in applications such as 2017-2018 Nissan Rogue, right; 2013-2015 Nissan NV200, right; and 2007-2012 Nissan Versa, right, as well as select Infiniti G20 and Nissan Sentra left-side applications. If you are replacing a leaking manual transmission output shaft seal on a Nissan Sentra, Nissan Altima, or Chevrolet City Express, Timken 710132 is the correct service part for the listed positions.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Seal Can Address

• Transmission fluid seepage at the output shaft
• Contamination entering the seal area
• Heat-related seal wear from poor lubricant circulation
• Leakage caused by minor shaft surface imperfections
• Damage from a worn or hardened original seal

Installation Notes and Tips

Inspect the shaft surface, seal bore, and surrounding components before installation. Clean the sealing area thoroughly and verify the replacement seal matches the vehicle position listed for your application, such as right-side Nissan Rogue or left-side Nissan Sentra. Proper seating is important for sealing performance, so install the seal evenly and avoid nicking the lip or outer case during assembly.

Quality Assurance

Timken oil and grease seals are engineered with features that support reliable sealing performance, including contamination exclusion and heat management through vented design.