Timken 710396 Manual Transmission Output Shaft Seal - Rear or Right

Manual Transmission Output Shaft Seal for Select Applications

Timken 710396 is a manual transmission output shaft seal built to retain lubricant and block contaminants at the transmission output. It is a direct-fit service part for select Honda, Ford, Mazda, Mitsubishi, and Plymouth applications, including the Honda S2000, Mazda Miata, and Mitsubishi Eclipse.

Key Features

• Precision sealing design helps keep transmission fluid in place and dirt out
• Reinforced outer case resists installation damage and adds durability
• Ribbed rubber inner diameter seals minor shaft imperfections and supports a secure seat
• Internal contamination exclusion system helps reduce debris intrusion that can lead to leakage
• Vent holes promote lubricant flow around the seal lip to reduce heat buildup
• Fits 2000-2009 Honda S2000, rear
• Fits 2001-2006 Ford Escape, N/A
• Fits 2000-2005 Mazda Miata, rear
• Fits 2000-2002 Mazda 626, right
• Fits 2000-2002 Mazda Millenia, N/A
• Fits 2000-2002 Mazda Millenia, right
• Fits 2000-2001 Mazda MPV, right
• Fits 1990-1995 Mitsubishi Eclipse, rear
• Fits 1992-1995 Mitsubishi Expo, rear
• Fits 1992-1994 Plymouth Laser, rear
• Fits 1990-1992 Mitsubishi Galant, rear

Detailed Description

Timken 710396 is a transmission sealing component for the output shaft area, where maintaining lubricant control is critical to drivetrain performance. The seal’s reinforced construction and ribbed inner diameter are engineered to seat securely on the shaft while helping compensate for minor surface wear. This makes it a practical replacement for vehicles such as the Mazda Miata, Honda S2000, and Mitsubishi Eclipse when the original seal has hardened, worn, or begun to leak.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Fix

• Transmission fluid seepage at the output shaft
• Contamination entering the transmission housing
• Leakage caused by worn or imperfect shaft surfaces
• Heat-related seal deterioration from poor lubricant circulation
• Drivetrain service issues tied to a damaged rear or side output seal

Installation Notes and Tips

Inspect the shaft surface and seal bore before installation. Clean all mating surfaces thoroughly, and verify the seal is oriented correctly for the application. Use care during installation to avoid distorting the outer case or damaging the sealing lip. Confirm vehicle position and transmission configuration against the fitment list before ordering.

Quality Assurance

Timken oil and grease seals use precision sealing designs, a reinforced outer case, and contamination-exclusion features to support reliable service in transmission applications. Timken 710396 is built for the listed fitments and the demands of manual transmission output shaft sealing.