Timken 710630 Manual Transmission Output Shaft Seal - Left or Right

Timken 710630 Manual Transmission Output Shaft Seal

Timken 710630 is a manual transmission output shaft seal built to retain lubricant and block contaminants at the transmission shaft. It is a direct-fit sealing solution for a wide range of Honda and Acura applications, including Honda Civic, Honda Accord, and Acura TSX models.

Key Features

• Precision sealing design helps control lubricant loss at the output shaft
• Reinforced outer case helps resist installation damage and improve durability
• Ribbed rubber inner diameter seals minor spindle imperfections and supports positive seating
• Internal contamination exclusion system helps keep debris out of the seal area
• Vent holes promote lubricant flow around the seal lip to reduce heat buildup
• Cross-references National 710630 and Quality-Built 13726 for the same application

Detailed Description

This Timken manual transmission output shaft seal is engineered for vehicles that need dependable sealing at the transmission output shaft. It is a strong match for fitment-based searches such as Timken 710630 Honda Civic manual transmission output shaft seal, Honda Accord transmission seal replacement, and Acura TSX output shaft seal applications. The design focuses on maintaining lubricant inside the transmission while helping prevent dirt and other contaminants from entering the sealing area.

Compatible With select Honda and Acura models across 2000-2019, including Honda Fit, Honda CR-V, Honda Element, Honda Insight, Honda CR-Z, Honda Crosstour, Honda Civic, Honda Accord, Acura ILX, Acura TSX, Acura RSX, and Acura NSX. Use the exact vehicle position listed in the fitment data when ordering.

Common Problems This Part Can Address

• Transmission fluid seepage at the output shaft
• Contamination entering the seal area
• Seal wear from heat buildup around the lip
• Leakage caused by minor shaft surface imperfections
• Damage from a worn or hardened original seal

Installation Notes and Tips

Inspect the shaft surface before installation and clean the sealing bore thoroughly. Confirm the correct side or position from the fitment list, since this part is listed for left, right, and N/A applications depending on vehicle configuration. Proper seating is important for sealing performance, so install the seal squarely and avoid nicking the lip during assembly.

Quality Assurance

Timken oil and grease seals use precision sealing designs, a reinforced outer case, and contamination-exclusion features to support reliable service in transmission applications.