Timken 9569S Wheel Seal - Rear

Timken 9569S Wheel Seal for Rear Axles

The Timken 9569S wheel seal is built for rear axle sealing on select Ford and Mercury applications. It uses a precision sealing design to keep gear oil and grease in place while helping block dirt and debris from entering the axle assembly.

• Reinforced outer case helps resist installation damage and supports seal durability
• Ribbed rubber inner diameter seals minor spindle imperfections and promotes positive spindle seating
• Internal contamination exclusion system helps reduce debris intrusion that can lead to leakage
• Vent holes allow lubricant flow around the seal lip to help manage heat buildup
• Rear wheel seal application for select Ford Ranger, Mustang, and Mercury Cougar, Monarch, and Montego models

Fitment Details

• Fits 1983-1984 Ford Ranger, rear, 6.7 inch ring gear
• Fits 1980 Mercury Monarch, rear
• Fits 1975-1979 Mercury Monarch, rear, Non WER axle
• Fits 1969-1973 Ford Mustang, rear, 1.38 in. axle - Non WCY axle
• Fits 1967-1973 Mercury Cougar, rear, 28 splines axle
• Fits 1969-1971 Mercury Montego, rear, 28 splines axle
• Fits 1968-1971 Mercury Montego, rear
• Fits 1967-1968 Ford Mustang, rear, Non WCY axle

What This Wheel Seal Helps Address

• Rear axle lubricant seepage at the wheel end
• Contamination entering the axle seal area
• Seal wear caused by heat buildup around the lip
• Minor spindle surface imperfections that affect sealing
• Leakage concerns on Ford Mustang, Ford Ranger, Mercury Cougar, Mercury Monarch, and Mercury Montego rear axle setups

Installation Notes and Tips

Verify axle configuration, ring gear size, spline count, and notes such as Non WCY or Non WER before installation. Clean the spindle and seal bore thoroughly, inspect for scoring or corrosion, and seat the seal evenly to avoid distortion. Timken 9569S is a rear wheel seal for the listed applications, so confirm the vehicle match before service.

Quality Assurance

Timken designs its oil and grease seals with precision sealing features aimed at controlling lubricant loss and keeping contaminants out of the assembly. This part number is Timken 9569S.