Timken HA590024 Wheel Bearing and Hub Assembly - Front Left

Timken HA590024 Wheel Bearing Hub Assembly

Timken HA590024 is a front left wheel bearing and hub assembly for the 2004-2007 Ford Freestar. Built for driven front applications, it combines hub, bearing, and ABS sensing functions in one OE-style replacement for smoother operation and consistent wheel-speed monitoring.

Key Features

• Fits 2004-2007 Ford Freestar, front left
• Driven hub assembly with 26 splines
• 5 wheel studs and 3 flange bolt holes
• Bolt circle diameter: 4.500 in. / 114.30 mm
• Wheel pilot diameter: 2.491 in. / 63.27 mm
• Brake pilot diameter: 2.802 in. / 71.17 mm
• Hub pilot diameter: 3.603 in. / 91.52 mm
• Flange diameter: 6.150 in. / 156.20 mm
• Flange offset: 1.639 in. / 41.63 mm
• ABS sensor is 100% tested for wheel-speed signal monitoring

Product Details

Timken HA590024 is engineered using OE-developed testing methods that guide the design, materials, and manufacturing process of the hub bearing assembly. The result is a front left replacement for the Ford Freestar that focuses on low runout, reduced noise and vibration, and stable braking feel. Premium bearing surfaces and precision internal geometry help support load capacity and bearing life, while the sealed design helps keep contamination out and maintain seal performance. This part cross-references Monroe Shocks & Struts (e.g., 513232, BR930435) for the same application. Timken HA590024 is a direct-fit choice for drivers searching for a Ford Freestar front left wheel bearing hub assembly with ABS sensor integration.

Common Problems This Part Can Address

• Wheel bearing noise from the front left corner
• Excessive wheel play or looseness at the hub
• ABS warning light caused by wheel-speed signal issues
• Brake pulsation or vibration related to hub runout
• Uneven tire wear linked to hub or bearing wear

Installation Notes

Confirm spline count, bolt pattern, pilot diameters, and front-left position before installation. Clean the mounting surface thoroughly and inspect related suspension and brake components for wear before fitting the new hub assembly. Verify ABS connector routing and sensor alignment during installation, then check wheel-speed data and road-test the vehicle after service. For 2004-2007 Ford Freestar applications, match the part to the driven front-left configuration shown in the fitment data.

Quality Assurance

Timken uses OE-developed test procedures to control hub bearing design, materials, and manufacturing consistency. The assembly includes premium seals, precision-profile bearings, and a tested ABS sensor to support reliable wheel-speed monitoring on compatible Ford Freestar applications.