Timken HA590142 Wheel Bearing and Hub Assembly - Front or Rear

Timken Hub Assembly for Chrysler and Dodge

Timken HA590142 is a wheel bearing and hub assembly built for front and rear applications on select Chrysler 300, Dodge Charger, Dodge Challenger, and Dodge Magnum models. It is engineered with OE-developed testing, low runout, and precision bearing surfaces to support smoother operation, reduced noise, and stable braking performance.

Key Features

• Wheel bearing and hub assembly for driven applications
• Low runout design helps reduce noise and vibration
• Premium seals with reinforced construction and contamination control features
• Precision bearing profiles and uniform internal geometry for load support
• ABS sensor is 100% tested for wheel speed monitoring
• Timken HA590142 cross-references MOOG 512301, SKF BR930446, and SKF BR930447

Detailed Product Overview

This Timken hub assembly is built around OE-developed validation methods that control design, materials, and manufacturing process. The bearing package uses enhanced surface finishes and internal geometry intended to improve load carrying capacity and bearing life, while the seal design helps maintain positive sealing and resist contamination. With 5 wheel studs, 4 flange bolt holes, a 115.00 mm bolt circle diameter, and a 71.40 mm wheel pilot diameter, this assembly matches the dimensional requirements for the listed Chrysler 300, Dodge Charger, Dodge Challenger, and Dodge Magnum fitments. Timken HA590142 is a direct-fit solution for front and rear service on the applications shown below.

What This Part Helps Address

• Wheel bearing noise from worn hub components
• Steering or chassis vibration related to hub runout
• ABS warning concerns tied to wheel speed signal issues
• Brake performance changes caused by hub instability
• Excessive play or roughness at the wheel end

Fitment and Installation Notes

• Fits 2005-2022 Chrysler 300, front
• Fits 2009 Chrysler 300, rear, Performance Package
• Fits 2005-2008 Chrysler 300, rear
• Fits 2007-2022 Dodge Charger, front
• Fits 2014 Dodge Charger, front, 13.6 in. Brake Rotor
• Fits 2009 Dodge Charger, rear, Performance Package
• Fits 2006-2008 Dodge Charger, rear
• Fits 2017-2022 Dodge Challenger, front
• Fits 2008 Dodge Challenger, rear
• Fits 2005-2008 Dodge Magnum, front
• Fits 2005-2008 Dodge Magnum, rear

Verify flange offset, bolt circle diameter, and brake pilot dimensions before installation. Confirm ABS connector routing and sensor alignment during service, and follow the vehicle manufacturer’s torque specifications for hub and wheel fasteners.

Quality Assurance

Timken manufactures hub bearing assemblies using OE-developed test procedures to control design, materials, and production consistency. The ABS sensor is fully tested for wheel speed monitoring, and the bearing and seal construction is specified to support long-term performance in demanding driveline and axle service.