Timken HA590280 Wheel Bearing and Hub Assembly - Rear

Timken Rear Wheel Hub Assembly for Sentra

The Timken HA590280 is a rear wheel bearing and hub assembly for 2007-2012 Nissan Sentra applications. Built for non-driven rear use, it combines precision bearing geometry, low runout, and integrated ABS sensing to support stable braking and smooth wheel rotation.

Key Features

• Fits 2007-2012 Nissan Sentra, rear
• Timken HA590280 wheel bearing and hub assembly for non-driven rear positions
• 4-bolt flange and 4 wheel studs
• Bolt circle diameter: 114.30 mm / 4.500 in.
• Wheel pilot diameter: 66.00 mm / 2.598 in.
• Brake pilot diameter: 68.00 mm / 2.677 in.
• Hub pilot diameter: 84.00 mm / 3.307 in.
• Flange diameter: 147.79 mm / 5.819 in.
• ABS sensor is 100% tested for wheel-speed monitoring

Detailed Description

Timken HA590280 is engineered for the rear hub location on the 2007-2012 Nissan Sentra. Timken uses OE-developed testing to control the design, materials, and manufacturing process of its hub bearing assemblies, helping maintain consistent performance. The low-runout design helps reduce noise and vibration while supporting braking feel, and the premium bearing construction uses precision profiles, uniform internal geometry, and enhanced surface finishes to improve load capacity and bearing life.

Premium sealing features a reinforced outer case, ribbed rubber inner diameter, internal contamination exclusion system, and vent holes to help protect the seal during installation and maintain sealing performance. This part cross-references SKF BR930691 for the same application.

What This Part Helps Address

• Rear wheel bearing noise on a Nissan Sentra
• Wheel vibration or rough rotation from hub wear
• ABS warning concerns related to wheel-speed signal loss
• Brake pulsation or inconsistent braking feel tied to hub runout
• Loose or worn rear hub assembly fitment

Installation Notes and Tips

Confirm rear position fitment before installation on 2007-2012 Nissan Sentra models. Verify bolt circle, pilot diameters, and flange dimensions against the original part before pressing or bolting the assembly into place. Inspect the mating surfaces, ABS connector routing, and surrounding brake components for wear or contamination before final assembly. The Timken HA590280 should be installed with care to avoid seal damage and to preserve sensor performance.

Quality Assurance

Timken hub assemblies are built using OE-developed test procedures and controlled manufacturing standards. The ABS sensor is fully tested for wheel-speed monitoring, and the bearing and seal design focus on consistent operation, contamination resistance, and long service life.