Timken HA590285 Wheel Bearing and Hub Assembly - Front

Timken HA590285 Front Hub Assembly

Timken HA590285 is a front wheel bearing and hub assembly for the 2007-2011 Nissan Versa. It combines OE-developed testing, precision bearing construction, and integrated ABS sensing to support stable wheel speed monitoring, smoother operation, and consistent braking feel.

Key Features

• Fits 2007-2011 Nissan Versa, front
• Driven hub assembly with 25 splines
• 4-wheel-stud, 3-bolt flange design
• ABS sensor is 100% tested for wheel speed monitoring
• Low runout construction helps reduce noise and vibration
• Premium seals help maintain sealing performance and resist contamination
• Precision bearing geometry supports load capacity and bearing life
• Cross-references SKF BR930682 and MOOG 513308 for the same application

Detailed Description

Built for the front axle of the Nissan Versa, Timken HA590285 uses OE-developed validation methods to control design, materials, and manufacturing process. The hub assembly features premium bearings with refined internal geometry and enhanced surface finishes, along with seals engineered to help protect against contamination and installation damage. Timken HA590285 also includes an ABS sensor that is tested to monitor wheel speed for anti-lock braking system operation.

For drivers searching for a front wheel bearing and hub assembly for 2007-2011 Nissan Versa, this part number provides the correct driven hub configuration with a 4.500-inch bolt circle, 66.00 mm wheel pilot diameter, 68.00 mm brake pilot diameter, and 80.00 mm hub pilot diameter. Timken HA590285 is a direct-fit service part for the specified Versa front application.

What It Helps Address

• Wheel bearing noise from worn or rough internal components
• Front-end vibration caused by excessive hub runout
• ABS warning concerns related to wheel speed signal issues
• Uneven braking feel linked to hub or bearing wear
• Loose or unstable wheel support at the front axle

Installation Notes and Tips

Confirm the vehicle is a 2007-2011 Nissan Versa with front application before installation. Inspect the mating surfaces, axle splines, and ABS connector condition during service, and verify all mounting points are clean and free of corrosion. After installation, check for proper wheel rotation, secure fastener seating, and correct ABS operation.

Quality Assurance

Timken manufactures hub bearing assemblies using OE-developed test procedures to help maintain consistent performance. The brand’s bearing and seal design focus on controlled runout, contamination resistance, and durable wheel-speed sensing for ABS-equipped vehicles.