Timken HA590380 Wheel Bearing and Hub Assembly - Rear

Timken HA590380 Rear Hub Assembly

Timken HA590380 is a rear wheel bearing and hub assembly built for the 2009-2014 Nissan Cube, rear. It is engineered for non-driven applications and focuses on low runout, stable wheel support, and consistent ABS wheel-speed signal performance.

Key Features

• Fits 2009-2014 Nissan Cube, rear
• Non-driven wheel bearing and hub assembly
• 4 flange bolt holes and 4 wheel studs
• Hub pilot diameter: 69 mm (2.717 in)
• Wheel pilot diameter: 66 mm (2.598 in)
• Flange diameter: 148 mm (5.827 in)
• Flange offset: 72 mm (2.835 in)
• ABS sensor function is 100% tested for wheel-speed monitoring

Detailed Description

Timken HA590380 is a direct-fit rear hub assembly for the Nissan Cube, designed around OE-developed testing for the materials, design, and manufacturing process used in the assembly. The low-runout design helps reduce wheel noise and vibration while supporting more consistent braking feel. Premium seals use a reinforced outer case, ribbed rubber inner diameter, internal contamination exclusion features, and vent holes to help protect the seal during installation and maintain sealing performance over time. The bearing design uses precision profiles, uniform internal geometry, and enhanced surface finishes to support load capacity, bearing life, and fuel efficiency. Timken HA590380 is also built with an ABS sensor that is fully tested to monitor wheel speed for the anti-lock braking system.

This part cross-references Monroe Shocks & Struts (e.g., BR930944) for the same application.

Common Problems This Part Can Address

• Rear wheel noise caused by worn hub bearings
• Vibration felt through the chassis or steering during driving
• ABS warning light concerns related to wheel-speed signal issues
• Uneven braking feel from excessive hub runout
• Loose or rough rear wheel rotation from bearing wear

Installation Notes and Tips

Confirm rear fitment by matching the vehicle year, model, and non-driven application before installation. Inspect the mounting surface, axle area, and surrounding brake components for wear or corrosion that could affect hub seating. Verify the ABS connector and sensor routing during installation, and torque fasteners to the vehicle manufacturer’s specifications.

Quality Assurance

Timken manufactures this hub assembly using OE-developed test standards for design, materials, and process control. The ABS sensor is 100% tested, and the bearing and seal construction are engineered to support consistent performance in rear wheel applications.