Timken HA590433 Wheel Bearing and Hub Assembly - Front

Timken HA590433 Front Hub Assembly

Timken HA590433 is a front wheel bearing and hub assembly built for 2011-2018 Honda Odyssey models. It combines OE-developed testing, precision bearing construction, and integrated ABS wheel-speed sensing to support stable braking, reduced vibration, and consistent wheel-end performance.

For drivers searching for a front wheel bearing and hub assembly for Honda Odyssey, Timken HA590433 provides the correct fitment and the design details needed for dependable daily use.

Key Features

• Fits 2011-2018 Honda Odyssey, front
• Driven hub assembly with 30 splines
• 5 wheel studs and 4 flange bolt holes
• ABS sensor is 100% tested for wheel-speed monitoring
• Low runout design helps reduce noise and vibration
• Premium seals use reinforced and contamination-resistant construction
• Precision bearing profiles and enhanced surface finishes support load capacity and bearing life
• Timken part number HA590433

Detailed Description

Timken HA590433 is engineered as a direct replacement hub bearing assembly for the front position on the Honda Odyssey from 2011 through 2018. The assembly uses precision internal geometry, uniform bearing surfaces, and a driven hub design with a 120.00 mm bolt circle, 152.00 mm flange diameter, 47.20 mm flange offset, 88.00 mm hub pilot diameter, 64.00 mm wheel pilot diameter, and 70.00 mm brake pilot diameter. These dimensions support proper wheel-end alignment and secure mounting.

Timken builds its hub assemblies using OE-developed testing to control design, materials, and manufacturing process. The result is a front hub assembly intended to maintain smooth operation, reduce runout-related noise and vibration, and support braking performance. If you need a Timken HA590433 replacement for a Honda Odyssey front wheel bearing and hub assembly, this part is built around the fitment and performance requirements of that application.

This part cross-references SKF BR930844 for the same application.

What It Helps Address

• Wheel-end noise from worn or rough bearings
• Vibration or shake felt through the steering or chassis
• ABS warning concerns related to wheel-speed signal issues
• Uneven hub rotation caused by excessive runout
• Brake feel changes caused by hub or bearing wear

Installation Notes and Tips

Confirm the vehicle is a 2011-2018 Honda Odyssey with front-position fitment before ordering. Match the spline count, bolt pattern, pilot diameters, and flange dimensions to the original hub assembly. Clean the mounting surface thoroughly and inspect related suspension and brake components for wear before installation. Because this assembly includes an ABS sensor, verify connector routing and sensor alignment during installation.

Quality Assurance

Timken uses OE-developed testing to control the design, materials, and manufacturing process of its hub bearing assemblies. Premium seals, precision bearing profiles, and tested ABS sensing support consistent wheel-end performance in the Honda Odyssey application.