Timken HA590585 Wheel Bearing and Hub Assembly - Front or Rear

Timken Hub Assembly for Jeep Cherokee

Timken HA590585 is a wheel bearing and hub assembly built for 2014 Jeep Cherokee front and rear applications. It is engineered with OE-developed testing, low runout, and precision bearing surfaces to support quieter operation, stable braking feel, and consistent wheel-speed signal performance.

Key Features

• Fits 2014 Jeep Cherokee, front
• Fits 2014 Jeep Cherokee, rear
• Non-driven hub assembly with 32 splines
• 5-wheel-stud, 4-bolt flange design
• Hub pilot diameter: 91.95 mm (3.620 in.)
• Bolt circle diameter: 110.00 mm (4.330 in.)
• Flange diameter: 130.23 mm (5.127 in.)
• Flange offset: 48.59 mm (1.913 in.)
• Wheel pilot diameter: 64.95 mm (2.557 in.)
• Brake pilot diameter: 69.93 mm (2.753 in.)
• ABS sensor monitoring is 100% tested

Detailed Description

Timken HA590585 is a direct-fit wheel bearing and hub assembly for the 2014 Jeep Cherokee, covering both front and rear positions listed in the fitment data. The assembly uses precision bearing profiles, uniform internal geometry, and enhanced surface finishes to support load capacity and bearing life, while low runout helps reduce noise and vibration. Timken HA590585 also includes premium sealing features designed to improve contamination control and sealing durability, and the ABS sensor is tested to monitor wheel speed for anti-lock braking system operation. This part cross-references SKF BR930899 for the same application.

What It Helps Address

• Wheel bearing noise from worn hub components
• Vibration or roughness felt through the chassis
• Brake pulsation related to hub runout
• ABS warning concerns tied to wheel-speed signal issues
• Loose or inconsistent wheel hub operation

Installation Notes and Tips

Confirm the vehicle position before installation, since this Timken hub assembly is listed for both front and rear 2014 Jeep Cherokee applications. Verify spline count, bolt circle diameter, hub pilot diameter, and flange dimensions against the original part before service. Clean the mounting surface thoroughly and inspect related suspension and brake components for wear that could affect hub performance. Timken HA590585 is a non-driven hub assembly, so it should be matched to the correct axle position and drivetrain configuration during replacement.

Quality Assurance

Timken manufactures hub bearing assemblies using OE-developed testing and controlled design, material, and process standards. The bearing and seal construction is built around precision geometry, contamination exclusion, and tested ABS sensor performance to support consistent operation in service.