Timken RDTC1 Wheel Bearing - Rear

Timken RDTC1 Wheel Bearing Kit

Timken RDTC1 is a Set-Right wheel bearing rebuild kit for driveline and axle service. It is built for applications that require accurate bearing setting in a pre-adjusted hub, with matched bearing sets and a precision-machined spacer for consistent assembly.

Key Features

• Set-Right rebuild kit for wheel bearing service
• Two matched Timken bearing sets included
• Precision-machined spacer for accurate bearing setting
• Helps simplify installation on pre-adjusted hubs
• High-strength alloy steel construction with precision profiles
• Enhanced surface finishes and high load ratings

Detailed Description

The Timken RDTC1 wheel bearing kit is engineered to reduce width variation found in standard bearings, helping maintain consistent bearing setting during hub rebuilds. That matters when servicing wheel bearing assemblies on vehicles such as Ford F-150 and Chevrolet Silverado 1500 applications that rely on precise hub setup for smooth operation and long bearing life. Timken RDTC1 is also referenced under cross-number RDSK1 for the same application.

Built with super-clean alloy steel and refined bearing surfaces, this kit is intended for technicians and DIY buyers who need a direct-fit rebuild solution for wheel bearing and seal service. The Timken RDTC1 package supports accurate assembly on compatible hub systems without manual bearing adjustment steps.

What It Helps Solve

• Excessive wheel bearing play after hub service
• Inconsistent bearing preload or setting during rebuilds
• Noise from worn or improperly set wheel bearings
• Premature bearing and seal wear in serviced hubs
• Installation issues tied to standard bearing width variation

Installation Notes and Tips

Verify hub and axle specifications before installation. Clean all mating surfaces, inspect the seal and hub components, and follow the vehicle service procedure for bearing setting and torque values. Timken RDTC1 is a wheel bearing rebuild kit, so proper measurement and assembly technique are important for correct hub operation.

Quality Assurance

Timken manufactures this kit with high-strength alloy steel, precision profiles, and enhanced surface finishes to support consistent bearing performance. The RDTC1 part number is a Timken Set-Right rebuild kit designed for accurate wheel bearing service.