TrakMotive CH-8024 CV Axle Shaft - Front Right

CV Axle Shaft for Neon Front Right

TrakMotive CH-8024 is a new CV axle shaft for the front right position on 1995-1997 Dodge Neon and 1995-1997 Plymouth Neon models. It is built for direct replacement service with the correct spline counts, ABS tone ring, and axle nut specifications for the listed applications.

Key Features

• Brand: TrakMotive CV Axle Shaft
• Part number: CH-8024
• Fits 1995-1997 Dodge Neon, front right
• Fits 1995-1997 Plymouth Neon, front right
• New axle shaft with neoprene boot material
• Inboard joint type: male
• Outboard joint type: conventional
• ABS tone ring included with 56-tooth toothed ring
• Axle nut included with M20 x 1.5 thread, 30 mm hex size, and cotter pin locking type
• Overall compressed length: 941 mm (37.05 in)
• 25 inboard splines and 23 outboard splines

Detailed Description

TrakMotive CH-8024 is a CV axle shaft for front right service on the Dodge Neon and Plymouth Neon from 1995 through 1997. This axle shaft uses a male inboard connection and a conventional outboard joint, with a neoprene boot and an included toothed ABS tone ring for applications that require wheel speed signal support. TrakMotive lists this part as a new replacement and notes that ABS axles fit non-ABS applications unless otherwise noted. The CH-8024 part number is also useful when cross-checking replacement options for the same vehicle application.

This part cross-references Cardone New 66-3056 and Anchor 2814 for the same application.

Common Problems This Part Can Address

• Clicking or popping noises during turns from a worn CV joint
• Vibration or shudder during acceleration from axle wear
• Grease leakage caused by a damaged axle boot
• ABS warning concerns related to a failed tone ring or axle signal component
• Loss of driveline smoothness from spline or joint wear

Installation Notes and Tips

Verify front right placement, spline count, axle nut thread size, and ABS tone ring requirements before installation. Confirm that the vehicle uses the listed 25-spline inboard and 23-spline outboard configuration, and inspect the hub, seals, and mating components for wear before fitting the new axle shaft. The included axle nut uses a 30 mm hex and cotter pin locking style.

Quality Assurance

TrakMotive identifies this CV axle shaft as an ISO 9001:1007 and TS 16949:2009 certified product line and backs it with a limited lifetime warranty.