TrakMotive CH-8119XTT CV Axle Shaft - Front Left or Front Right

Extended Travel CV Axle for Ram 1500

TrakMotive CH-8119XTT is an Extended Travel CV Axle Shaft built for front axle applications that need more suspension movement than a standard OE-style shaft. It is engineered for 2006-2011 Dodge Ram 1500 and 2011 Ram 1500 front right or front left positions, with fitment notes for extreme articulation and Chrysler 8.25" ring gear applications.

The Extended Travel CV Axle Shaft line uses a sliding center bar to provide up to 44 mm more travel than an OEM CV shaft, and the CV joints can reach up to 47 degrees of articulation versus a typical OE joint at 23 degrees. Part number CH-8119XTT is a new axle assembly with a hex axle nut included and a self-locking M24x2 nut specification.

Key Features

• Extended Travel CV Axle Shaft for front suspension movement beyond standard OE range
• Sliding center bar design for increased axle travel
• Up to 47-degree CV joint articulation for extreme articulation setups
• New construction with TPEE boot material
• Female inboard joint with spline connection
• Conventional outboard joint with spline connection
• Axle nut included; hex head, self-lock, M24x2 thread
• Overall compressed length: 23.75 in. (603 mm)

Detailed Description

TrakMotive CH-8119XTT is a front CV axle shaft for Ram 1500 and Dodge Ram 1500 applications where additional suspension travel is required. This part is built for extreme articulation use and is listed for 2006-2010 Dodge Ram 1500 front right and front left, plus 2011 Ram 1500 front right and front left. Fitment notes specify use with Chrysler 8.25" ring gear applications, exclude Mega Cab on 2006-2010 models, and warn against use with lifted suspensions. The inner boot may contact the control arm when used with 2-3 inch leveling kits.

This part number, CH-8119XTT, is part of TrakMotive’s Extended Travel CV Axle Shaft line, which focuses on added axle movement and higher joint articulation for demanding front suspension geometry. It is a direct-fit style replacement for the listed Ram 1500 applications and is built new, not remanufactured.

This part cross-references TrakMotive CH-8119XTT for the same application.

What It Helps Address

• Front axle binding in Ram 1500 setups with increased suspension movement
• CV joint angle limitations in extreme articulation applications
• Axle travel restrictions compared with standard OE shafts
• Front driveline issues tied to worn or damaged CV axle assemblies
• Fitment needs for listed Dodge Ram 1500 and Ram 1500 front positions

Installation Notes and Tips

• Fits 2006-2010 Dodge Ram 1500, front right and front left, excluding Mega Cab.
• Fits 2011 Ram 1500, front right and front left.
• Not for use with lifted suspensions.
• For extreme articulation applications only.
• Inner boot may contact the control arm when used with 2-3 inch leveling kits.
• Always verify spline count, axle nut specification, and ring gear application before installation.
• Replace in pairs when servicing the front axle system.

Quality Assurance

TrakMotive CH-8119XTT is a new CV axle shaft built to the listed dimensional and fitment requirements, including 29 inboard splines, 33 outboard splines, and a 35.5 mm axle nut hex size. The extended travel design is intended for applications that require greater articulation than a typical OE CV joint.